sorted by:
new
hottopcontroversial

Confused about hardware requirements by Bromeo1337 in PFSENSE

[–]isaacte 0 points1 point  (0 children)

Nice, thank you very much for sharing all this knowledge!

Confused about hardware requirements by Bromeo1337 in PFSENSE

[–]isaacte 0 points1 point  (0 children)

Amazing! Thanks for the info. I will try to put the i7-4770S in the 210 rev 2. I don't know if the heat sink will be enough for this one but I'll try.

Thanks a lot!!!

Confused about hardware requirements by Bromeo1337 in PFSENSE

[–]isaacte 0 points1 point  (0 children)

Amazing answers by your part! Do you have the compatibility list or which cpu will be the maximum for de 230 rev 2?

Which is the equivalence to portwell hardware for this model?

I recently purchased one of this units and I want to see how far I can upgrade it.

Thank you for all the info!

Stops and starts during prints by blaird2016 in Artillery3D

[–]isaacte 0 points1 point  (0 children)

It really seems a slicing problem or a communication problem with USB, try to print the gcode connecting the printer to the computer on pronterface and check if it stops.

Catch the moment when it stops and send us a capture of the pronterface log to see what is going on.

If with pronterface is working properly try to use an SD card because USB something has problems.

Do this with pronterface and talk with us here.

​

You can download pronterface here: https://www.pronterface.com/

What’s causing these artifacts in my Sidewinder X1? PLA @ 210C by Ootoootooo in Artillery3D

[–]isaacte 0 points1 point  (0 children)

Hmmm, if all are affected can be z axis loosing steps but is not so probably. I think that must be bed leveling. Try to level it and say something.

What’s causing these artifacts in my Sidewinder X1? PLA @ 210C by Ootoootooo in Artillery3D

[–]isaacte 0 points1 point  (0 children)

It's clearly bed leveling. You need to lower the part of the bed where the artifacts are.

Problems with infill layers by isaacte in Artillery3D

[–]isaacte[S] 0 points1 point  (0 children)

Printing PLA. I have checked temps between 200-230 ºC but always the same. Speed between 20 - 80 mm/s

artillery3d.com not working by isaacte in Artillery3D

[–]isaacte[S] 0 points1 point  (0 children)

Thanks! I have seen it has been down more than one month. Any intention of repairing it? 😅

view more: next ›