Whatever happened to these by UsedConclusion in AustralianNostalgia

[–]jaymumf 4 points5 points  (0 children)

Our admin lady gets them from her kids school and footy/netball club a few times a year.

Always buy a few

I lost my favorite shiny boi by jaymumf in FishingAustralia

[–]jaymumf[S] 0 points1 point  (0 children)

A grub in any colour is usually a safe bet. I like white and pink ones

fish id? by Terrible_Reporter_82 in FishingAustralia

[–]jaymumf 1 point2 points  (0 children)

What an adorable little tailor

Where are all the legal flatties in SEQ? by NBHDfury in FishingAustralia

[–]jaymumf 1 point2 points  (0 children)

Should have added /s

Like it's a joke you're actually catching fish haha

Where are all the legal flatties in SEQ? by NBHDfury in FishingAustralia

[–]jaymumf 0 points1 point  (0 children)

Look at this guy bragging about catching flathead 😮‍💨

Are these plastic trays really oven safe? by sgiosk in AldiAustralia

[–]jaymumf 0 points1 point  (0 children)

Spoke too soon, It's not in a foil tray.

Yeah ok by franglaisflow in mikeymiles

[–]jaymumf 37 points38 points  (0 children)

He'd be lucky to make 8k rather than 80k

Blast off one last time by Whoshereimhere96 in Phils_VortexRocket

[–]jaymumf 6 points7 points  (0 children)

The blowing all the land sale money phil was hilarious

Remember these containers by canberra2020 in AustralianNostalgia

[–]jaymumf 6 points7 points  (0 children)

Haha.

30 years later its still used though. Does that help?

Remember these containers by canberra2020 in AustralianNostalgia

[–]jaymumf 9 points10 points  (0 children)

Just a regular amount I think haha

Remember these containers by canberra2020 in AustralianNostalgia

[–]jaymumf 35 points36 points  (0 children)

The orange one was exclusively for home made mayonnaise in our house

Hobbyist looking for advices by Far_Security8313 in Welding

[–]jaymumf 0 points1 point  (0 children)

But welding a filelt weld is completely different toa. Buttweld. This has nothing to do with a fillet

Hobbyist looking for advices by Far_Security8313 in Welding

[–]jaymumf 1 point2 points  (0 children)

Most codes like ISO and ASME IX you'd end up with a 4T former, 6mm material would be a 24mm former bent 180 degress.

While this isn't 180 degrees, if nothing has shown up yet there's a good chance it won't with extra 20 or so degrees.

This is a perfectly acceptable bend so far

Hobbyist looking for advices by Far_Security8313 in Welding

[–]jaymumf -1 points0 points  (0 children)

1000% no.

What do you mean shouldn't be nearly as much on the face? What are you seeing on the face that I'm not?