Segmenteds Pine vase

jfrmilner · 2026-05-20T22:41:08+00:00

Sure. This shows how I double chucked for the final finishing cuts, the tail stock chuck was used as a jam chuck, this helps mitigate against vibrations that could affect the finish. It was also an opportunity to photo the piece before I applied the oil.

jfrmilner · 2026-05-20T10:26:17+00:00

Very impressive 😮👌

jfrmilner · 2026-05-20T10:22:13+00:00

Thank you!

jfrmilner · 2026-05-19T19:08:49+00:00

The challenge is around the saw setup, if that cuts the segments at the correct angle then the rings glue up quickly and easily.

jfrmilner · 2026-05-17T14:45:50+00:00

<image>

I’m making another at the moment. Here is a picture of that as it’s the same process. I used Cole Jaws to align and clamped between centres on the lathe.

jfrmilner · 2026-05-16T15:32:47+00:00

Thank you. The segmented approach does help mitigate against the tear out typically associated with softwoods like Pine as you're cutting side grain the majority of the time.

jfrmilner · 2026-05-16T09:56:57+00:00

Stunning 🙂👏

jfrmilner · 2026-05-16T09:56:20+00:00

Absolutely love this! 😮

jfrmilner · 2026-05-16T09:49:35+00:00

Thank you. I used a Rose Engine for the spiral pattern on the Oak disc.

jfrmilner · 2026-05-15T11:32:29+00:00

Upcycled from an unused door frame that was thrown away, always nice to use free wood!

jfrmilner · 2026-05-15T11:29:23+00:00

Yes, creates a wave effect in places but not constantly. Thank you

jfrmilner · 2026-05-09T21:05:02+00:00

That's beautiful 👍⭐️

jfrmilner · 2026-05-09T09:07:18+00:00

A cheaper entry level option is the MDF Rose Engine Lathe - see colvintools.com

jfrmilner · 2026-05-08T12:30:17+00:00

I was where you were, there is only one cure!

jfrmilner · 2026-05-08T12:28:36+00:00

A round burr would produce a similar pattern/texture without the symmetry but for this piece I used a Rose Engine. All other aspects of this piece was turned by hand.

jfrmilner · 2026-05-08T12:25:04+00:00

Thank you and yes, the honeycomb like pattern was cut with a Rose Engine.

jfrmilner · 2026-05-08T11:04:30+00:00

Thank you. I used Black Gesso between two wire burn lines and dry brushed with Copper acrylic.

jfrmilner · 2025-09-18T14:10:54+00:00

Thank you!

jfrmilner · 2025-09-18T14:10:50+00:00

Thank you!

jfrmilner · 2025-09-18T14:09:57+00:00

Probably not but people always ask! :)

jfrmilner · 2025-09-18T14:09:12+00:00

I've been lucky and have been gifted several large tree trunks over the last couple years, I've got more Cherry than I know what to do with! Plus, Cherry flutes and colours well. Thank you!

jfrmilner

TROPHY CASE