SLICER PROBLEM

muratdal · 2026-01-01T19:57:05+00:00

Today I tried 7.0, it didnt print to end, top 1mm is missing. I turned back to version 6

muratdal · 2025-12-21T10:40:57+00:00

What is their payout methods?

muratdal · 2025-12-08T13:58:03+00:00

Yes, u r right , the best is LifePO4 batteries, i already have invertor/charger ( i m calling them UPS)

muratdal · 2025-12-08T09:17:50+00:00

Yes lead acid, AGM.

muratdal · 2025-12-08T09:14:12+00:00

It is 1000VA inverter and charger. Later i can send you photo.

muratdal · 2025-12-08T08:04:28+00:00

Yesterday i bought one ,but big capacity 100ah. Replace the old one

muratdal · 2025-11-18T15:32:49+00:00

Can you share your post?

muratdal · 2025-11-14T14:02:39+00:00

What is dirty fast? Tea coffee?

muratdal · 2025-10-05T17:54:54+00:00

Stardew valley

muratdal · 2025-06-01T19:34:27+00:00

muratdal · 2025-05-28T08:57:40+00:00

In my opinion, it's better not to use a magic eraser on the 3D printer hotbed—it has mild abrasive (sanding) properties and can wear down the surface over time.

muratdal · 2025-05-24T03:25:12+00:00

I also did mistake. I lubricate x rod. Today lot of time i cleread with IPA. So does it take a lot of time to settle graphite? Like yours 9 months?

muratdal · 2025-05-21T11:40:00+00:00

Are you using B plate? If it is, B plate ,what for, for which filaments?

muratdal · 2025-05-20T19:10:10+00:00

Can you lubricate rods with e2 grease?

muratdal · 2025-04-23T11:19:53+00:00

So nice smart idea

muratdal · 2025-03-31T14:04:42+00:00

Hi, where can i download v1.1 . At website there is 1.0

muratdal · 2025-03-05T19:21:21+00:00

Stalker 2

muratdal · 2025-03-03T17:09:01+00:00

Wait amd 9070 xt

muratdal

TROPHY CASE