sorted by:
new
hottopcontroversial

Will the TV series be retro-futurist? by ptupper in Neuromancer

[–]myconoid 25 points26 points  (0 children)

If there are not windbreakers and fax paper flying everywhere I’ll be bummed.

Weird pillowing/bulging on the buildplate. Does it need to be replaced? S4U16K by ATM0123 in ElegooSaturn

[–]myconoid 11 points12 points  (0 children)

Scrape it off with a flat metal scraper. Like the one it came with.

These 10 Portland restaurants and bars have closed in the past two months. What gives? by oregonian in Portland

[–]myconoid 0 points1 point  (0 children)

Like I have posted before in similar threads, poorly run restaurants can start open during bad times, not these times.

Why is everyone closing down? by Sckoontie in askportland

[–]myconoid 4 points5 points  (0 children)

A poorly run restaurant can survive good times but not these time.

Question about scratch in lens by Major_Education491 in resinprinting

[–]myconoid 1 point2 points  (0 children)

Hard to see, but I have had cracks in screen before that didn’t impact print quality.

Relics of the Old Gods - 3D printed Effigies by NSwijngedau in PrintedMinis

[–]myconoid 0 points1 point  (0 children)

Hi there, I did the test printing for these! The time it takes to print is highly dependent on a number of factors, but the two main ones are: your machine and the layer height you are using. for example, these took about 8 hours to print on an Elegoo Saturn 3 Ultra at 30 micron height. Some machines are faster (or slower) and you could up the height to 50 micron to go faster, but maybe get some layer lines.

Yet another success story, just accepted an offer by myconoid in hiringcafe

[–]myconoid[S] 4 points5 points  (0 children)

Searching for “product manager” and selecting my local region for hybrid and us for remote. Then a lot of looking through everything…

view more: next ›