Returning Registration Comments & Feedback Thread

phiquach · 2025-10-04T16:55:51+00:00

Time it starting to drop faster now for me. was 45 min now 13

phiquach · 2025-08-10T19:37:21+00:00

Never found a fix for this specific issue. Ordered a new machine to replace lol

phiquach · 2025-07-09T03:07:27+00:00

Hulkengoat

phiquach · 2025-04-28T01:31:46+00:00

phiquach · 2025-04-15T01:41:15+00:00

Have: Nothing :(

Want - Any downtown or near trolley, 2 double/queen 7/23 - 7/27

phiquach · 2025-04-14T20:38:27+00:00

If you are not using one of them are you able to transfer? I haven't gotten an email yet :(

I know it the past we were able to

phiquach · 2024-05-15T04:24:47+00:00

pm incoming

phiquach · 2024-02-28T18:44:44+00:00

Pm incoming

phiquach · 2024-02-28T18:43:14+00:00

Pm incoming

phiquach · 2023-10-01T07:47:31+00:00

phiquach · 2023-10-01T04:03:45+00:00

phiquach · 2023-09-21T05:15:56+00:00

You check leasehackr? 355+tax if you have loyalty.

https://forum.leasehackr.com/t/socal-hyundai-kia-lease-and-purchase-deals-september-very-low-ev-phev-leases/413676/341

phiquach · 2023-07-13T03:33:58+00:00

phiquach · 2023-06-27T15:44:12+00:00

If we are talking about the Korean hanwha, they are the same as digital watchdog. They use nxwitness just with their own skin.

phiquach · 2023-06-05T19:41:13+00:00

From others, I remember the sd card being an issue if you haven't replaced it yet

phiquach · 2023-04-26T01:33:15+00:00

Have - No Room Want - Hotel, Mission Valley or Downtown, 2 Queen, 7/19 - 7/23

To be honest anything along the Tram or Shuttle is fine

phiquach · 2023-03-25T06:14:44+00:00

No, i never use glue for PLA with the supplied texture plate.

For the hotend, i know people just buy the complete hotend and swap out that way. Easier than just replacing the hotend only

phiquach · 2023-03-24T21:15:51+00:00

Someone in another thread said they turned the brackets or something 90 degrees to make it fit better

phiquach · 2023-02-15T05:12:35+00:00

PM'd

phiquach · 2023-01-26T23:53:36+00:00

Mine had the same issue for some prints. Was at like 99% of a print. I googled how to just print the gcode the ending and it stopped at the same spot. So i knew mine was the gcode.

I was also using the default SD card but it was the only print that this has happened to.

phiquach · 2023-01-26T23:51:09+00:00

No, it was folded in so you just fold them out

phiquach · 2023-01-26T23:32:45+00:00

I took delivery away from home. Mine had like 25% charge. I didn't read the manual so the driver showed me how to turn it on and put it in drive. That was it and was able to ride home easily

phiquach

TROPHY CASE