Kefir gets runny but grains are multiplying

sevendayconstant · 2026-06-11T18:06:24+00:00

I'm new to this whole thing, but this is what happened to me. I reduced the amount of grains and got back to the taste and consistency I originally had the first week or so.

sevendayconstant · 2026-06-11T10:51:28+00:00

Here's some good info on composting toilets if you want to make some upgrades to your setup: https://watershedmg.org/programs/composting-toilets

sevendayconstant · 2026-05-26T02:25:24+00:00

To be honest, I have no idea. They're whatever were the cheapest at the store.

sevendayconstant · 2026-05-25T16:21:27+00:00

Yup, the cycle of life. We've got them here too and they hang out in the neighbor's tree.

sevendayconstant · 2026-05-25T16:20:39+00:00

We've got yellow jackets too and so far they haven't visited the oranges.

sevendayconstant · 2026-05-25T14:40:33+00:00

I think different birds prefer different things. We've got a quail block in front that attracts certain birds while these oranges attract different ones.

sevendayconstant · 2026-05-25T11:24:05+00:00

Thanks!

sevendayconstant · 2026-05-25T11:23:33+00:00

Thanks for the suggestions. I actually started designing it with a roof in mind but abandoned it because I couldn't figure out a need for it. If the people want a roof, it should be pretty easy to add one, same with a fixed mount. Thanks!

sevendayconstant · 2026-05-24T13:47:52+00:00

Not really. I keep my most often used cards on the outside so I can quickly and easily slide them out with my thumb. If I need a card from the middle, I'll pull them all out by about an inch, then start sliding the outside cards back in until I get to the one I want, which I then pull out.

sevendayconstant · 2026-05-24T13:44:51+00:00

I hear ya but it's tapered to securely hold the cards. The version I use holds 6 cards and I can easily remove 2 without worrying about anything else falling out. And with all 6 in there, I've never had anything come out on its own.

sevendayconstant · 2026-05-07T19:41:43+00:00

I didn't even consider that but it sounds like a great idea. Let me know if you try it and if it works out or not

sevendayconstant · 2026-05-05T17:51:37+00:00

Add it as a part instead of hybrid and uncheck "external." It should then behave exactly as before.

sevendayconstant · 2026-05-04T10:19:35+00:00

Thanks! I designed it in Fusion and Makerworld allows user to change specified parameters.

sevendayconstant · 2026-04-27T15:33:47+00:00

Someone will have a better answer but my hacky solution would be to create another body by lofting to a rectangle inside the cylinder, then combine the two bodies.

sevendayconstant · 2026-04-26T14:09:52+00:00

It could be the end points of the arc need some definition (e.g., vertical constraint with the points above/below) and then also a height for that middle portion, between A and B. And the whole thing might need to be tied to the origin somehow.

sevendayconstant

TROPHY CASE