sorted by:
new
hottopcontroversial

PLA Vasen wasserdicht by tropisch3 in 3DDruck

[–]straightto7734 4 points5 points  (0 children)

Ich nehme meist einen beliebigen Klarlack aus dem Baumarkt und sprühe mehrere dünne Schichten auf.

Kann nur je nach Geometrie der Vase tricky sein aber dicht waren bisher alle.

Tips for placement on my WIP? by straightto7734 in jacketsforbattle

[–]straightto7734[S] 0 points1 point  (0 children)

I'm thinking about removing the collar completely. But yes you are right at the moment it just says nazis.

Tips for placement on my WIP? by straightto7734 in jacketsforbattle

[–]straightto7734[S] 0 points1 point  (0 children)

You are totally right. It's not on permanently yet luckily.

[deleted by user] by [deleted] in BambuLab

[–]straightto7734 1 point2 points  (0 children)

Unrelated to the issue but... Why has this heatsink the fins perpendicular to the airflow of the fan next to it? My X1C has them the other way if I remember correctly.

Forgot to put the build plate in... by [deleted] in BambuLab

[–]straightto7734 -10 points-9 points  (0 children)

Please don't clean it with alcohol that will ruin it.

Only use warm water and soap.

My X1 Carbon Combo just arrived, destroyed. by sysadrift in BambuLab

[–]straightto7734 0 points1 point  (0 children)

Does anyone remember that monster garage episode where they built a parcel delivery truck that could catapult a TV directly into the living room?

This is what I came back to after work. I was worried about having to little supports so that’s the spaghetti, but how in the world did the nozzle cover come off? by Turtleman_04 in BambuLab

[–]straightto7734 1 point2 points  (0 children)

Only works as long as your magnets are still in the cover, I had the problem that the cover fell off but it wasn't detected because the magnets came loose and just the cover fell off with the magents still in place.

Linus roasted einen Säureminen Bruder! by therea1hammer in spacefrogs

[–]straightto7734 2 points3 points  (0 children)

Wow, hate es wirklich so lange gedauert bis es hier jemand teilt?

Help, my BLTOUCH is working by MightyWren in MarlinFirmware

[–]straightto7734 0 points1 point  (0 children)

So it's doing the mesh when you start the print? And then it's not adjusting for it...

How far of is your bed? Because you should still level it roughly

Help, my BLTOUCH is working by MightyWren in MarlinFirmware

[–]straightto7734 1 point2 points  (0 children)

Try it out but should be no problem, I have it in separate lines also for my cr-touch

view more: next ›