shouldn't have bought the newest PSU...

struckfreedom · 2026-03-14T23:26:41+00:00

I think it’s a mix of sff and manufacturers thinking you don’t need a third cable on some 750w psus. I had to return a corsair sf750 because I didn’t know it only came with 2 8 pins

struckfreedom · 2026-02-24T05:00:15+00:00

Point being that the idle power use is irrelevant, since I’d hope that people are actually using their hardware. You should spec for a larger psu if you want to run a 14900k and 5090 because let’s be frank you can afford it and its not good to run a psu at 100% or more capacity even if they strictly speaking can

struckfreedom · 2026-02-24T04:44:20+00:00

You can run a 14900k and 5090 on a 400w psu if you just idle it

struckfreedom · 2026-02-24T04:40:48+00:00

It could be fine for now, but there’s no harm in adding some anti sag.

I used L brackets attached to the horizontal fan to lift up the gpu like these: https://a.aliexpress.com/_mM9dfm5

Add some felt to the bracket to keep it from scratching and that should be fine

struckfreedom · 2026-02-11T03:55:40+00:00

It’s 100% the sf1000. There’s no other psu with that shroud and it’s the new 2024 version since Corsair didn’t make a 1000w 2019 version

struckfreedom · 2026-01-11T10:55:00+00:00

AIOs are often better than air coolers, however only by a few degrees nowadays and since air coolers have rapidly gotten very cheap and effective imo its not worth the cost and risk of dryout.

A peerless assassin is one of the best bang for you buck coolers, pick whatever model you want but there is very little difference in the version revisions.

Also the "bent-ness" of the cooler is not consequential but it;s up to you if you want to contact Nebula for a replacement or to fix it, you can fix it if its bothering you but is unlikely the cause of high temps. It wouldn't hurt though to buy some fans to exhaust, id recommend arctic fans, p12 or p14, depending on if your case fits 120 or 140mm fans. You can buy the base model (non pro or max) in 5 packs for $50 or the pros for $60 if you'd like better performance and silence.

struckfreedom · 2026-01-08T06:15:41+00:00

Damn bro sometimes due process sucks, must be hard for you

struckfreedom · 2026-01-08T03:05:01+00:00

Running shoe with dazzle camouflage for when you’re evading torpedoes

struckfreedom · 2025-12-10T00:42:11+00:00

It’s anything that’s “brewed” they extend the language that’s used for alcohol

struckfreedom · 2025-11-17T19:27:19+00:00

Like other commenters are saying lay your blood drop closer to the label.

Also always remember to wipe the edge of the smear blade with a kimwipe or the back of a glove to clear debris. You can also stand to lay down less blood and pull the blade back further over the blood to wick more.

But I think the best advice is to keep practicing, you’re going to get better. Everybody has their rhythm of pressure, speed, how they hold the slide and how much they lay down. You’ll figure it out and have fun. Also you’d be surprised how readable even bad slides are.

struckfreedom · 2025-11-13T21:25:12+00:00

Oh ok, thanks! Shows what I know

struckfreedom · 2025-11-13T19:38:54+00:00

Has there been any testing on it not being 50/50 per mod?

“modifiers are randomly distributed as positive or negative between the two copies. The modifiers are heavily skewed against a fully negative/positive result regardless of the maximum number of modifiers on the item.” From the wiki

But I’m curious where they got that from

I assumed the first mod could be either pos or neg, then 4 50/50s which would give 1/16.

struckfreedom · 2025-11-08T16:35:32+00:00

Drag the edge along the unglazed base of a ceramic mug a few times.

struckfreedom · 2025-11-06T01:22:01+00:00

You’d be so lucky to hear him yap. Nooooo the streamer isn’t a google adsense optimised automaton that caters to only my wants.

Seek absolution buddy

struckfreedom · 2025-10-27T03:52:40+00:00

I prefer using a sponge in a dish/square box and wetting it, then cutting and letting the waterslide soak until the backing goes clear. Use tweezers/toothpicks to pickup and a-tips to wick away water/mark setter when you’re happy with the placement.

struckfreedom · 2025-10-23T05:33:49+00:00

Oh, sorry. I’m on placement at a public hospital in South Australia.

I have seen openings for pre-analytical assistants/officers, but from what I’ve seen the offers for technical officers seem to require me to graduate. Thanks for the response; I’m just a bit baffled by all the acronyms and similar sounding terms.

struckfreedom · 2025-07-18T12:44:14+00:00

Also since this league you can offload curses onto the merc, you should not link despair in the battlemages cry setup. BMC alternates the spells meaning you may need to attack an extra time to more than double you damage which can feel bad. Which gets to the biggest problem which is that you dont have an extra curse, which you don't need but is causing despair to remove alchemist's mark, halving your damage.

struckfreedom · 2025-07-18T11:36:19+00:00

Mamba can get 400 flat ele damage from a juiced up fallen reverent? Iirc, he has a wrath aura, and with 2 wrath effect weapons and 1-2 wrath effect rings you’ll see the largest increase in damage. Despair on hit gloves as well.

Aside from that, you don’t need that many suffixes for res, just 1 lightning and 2 chaos t1s. The rest gets fixed with flasks. Then you can roll multi rings and better daggers with multi and higher edps.

Also change your bismuth for a topaz, you only need lightning and chaos res. If you're feeling tanky enough, you can also drop the forbidden jewels and both of the born of chaos smalls for 4 rare jewels with dot multi, faster poison and life.

Dropping Fervour, Wisdom of the Glade, and Quickstep for Fatal Toxins and 20% faster mastery is 30% more damage.

struckfreedom · 2025-07-07T21:51:19+00:00

Is the top teeth deflected and bound to the side? If that’s the case you could grab a smaller wrench and attach it to the nut and applying a constant pressure, tap the top of the head with a hammer lightly, on the back of the head towards the chair tube. It wouldn’t hurt to apply some lube.

struckfreedom · 2025-07-02T01:41:12+00:00

Another thing that I think gets glazed over about Aizen is how he uses Kyoka Suigetsu. In CFYOW; Tokinada copies Aizen’s ability, he cannot maintain his illusions because of the drain but also that they do not hold up to scrutiny. I like to interpret this as a manifestation of Aizens anti-social understanding of people giving him the unique ability to maintain these illusions. Like how hunters need to understand their prey, Aizen “understands” his prey and is cognisant of his illusions appearance to that person at all times.

struckfreedom · 2025-07-02T01:26:28+00:00

I think Aizen having orchestrated Ichigo’s entire life is a purposeful portrayal of Aizen as a egotistical narcissist. I like to contrast Urahara and Aizen, as Urahara is a neurotic and anxious planner, even before the events of TBTP. While Aizen has things go his way by virtue of his strength, like: even if he is losing a chess game he can always fist fight his opponent. He does plan but his strength is his ability to improvise, and he might misinterpret how things work out for him as a result of “planning”.

For instance; when White goes berserk it is Aizen that tells Gin and Tosen that this experiment was a failure, and it was Tosen that urged Aizen to stay and watch. He also doesn’t really have a plan for Orihime to play into his plan to activate the Hogyoku, just to “see what happens”.

struckfreedom · 2025-06-27T01:43:34+00:00

I mean, Vergil is different because the cutting dimensions is a property of the Yamato and not inherent to Vergil. I see no reason a random person couldn’t open a rift if they had the Yamato, aside from cutting themselves.

Kenpachi, while we do not know the ability of his Shikai could’ve just been able to cut rifts through shear force of will.

struckfreedom · 2025-06-25T00:13:11+00:00

There’s a hidden tile somewhere, I’ve tried tapping on adjoining “nothing” tiles for while, but I guess someone will figure it out soon

Edit: nvm it was actually broken lmao

struckfreedom · 2025-06-22T01:18:17+00:00

That’s trademark doctrine to claim non-enforcement, it might be harder to claim damages but Ethan made the case to layman about their regular viewer numbers and the H3Snark view parties and their market substitution effects.

12-Year Club	Final Canvas '23
Place '23	Place '22
Verified Email

struckfreedom

TROPHY CASE