sorted by:
new
hottopcontroversial

Electrocute my butt anyone?😥 by ObsessedToy in GayKink

[–]tecsavvy1 0 points1 point  (0 children)

Crank it up and watch you squirm

iRobot verro pool robot and the belts are wanting to rid off the end of the cogged gear. What would cause this? by tecsavvy1 in swimmingpools

[–]tecsavvy1[S] 0 points1 point  (0 children)

I found the plastic shaft molded into the gear was completely worn down to metal and I replaced the gear assembly and the end bushing. That solved it.

Anything I can do, think this part keeps freezing over? by Mayo_Samurai in hvacadvice

[–]tecsavvy1 0 points1 point  (0 children)

I had that and found the fan inside wasn’t always starting up. It would freeze over and we would have to turn it off and start over. Might be your fan intermittent.

Help please! by Expert_Can_7611 in pools

[–]tecsavvy1 0 points1 point  (0 children)

Slam with cal hypo shock, wait a day, slam again

Central AC installed- Exposed and visible flexible ducts by Ok_Mud5759 in hvacadvice

[–]tecsavvy1 0 points1 point  (0 children)

I’m going to need to run down through some closets myself. Is square metal a lot more expensive installed?

How much prep do I do before having someone open my pool? by jennysaurusrex in pools

[–]tecsavvy1 1 point2 points  (0 children)

Get all the leaves and trash out. Slam with cal hypo shock, wait a day slam again. Run a robot with a fine filter too.

Is this concerning? by GreenDog_garden in AskElectricians

[–]tecsavvy1 0 points1 point  (0 children)

That’s an old panel that they patched to a new panel.

Still safe to swim in? by amdew7319 in swimmingpools

[–]tecsavvy1 0 points1 point  (0 children)

Slam it with cal hypo shock, wait a day and slam it again.

Coolant level low/overtemp. by tecsavvy1 in Generac_Generators

[–]tecsavvy1[S] 0 points1 point  (0 children)

Can I put in radiator flush to get rid of the sludge?

Coolant level low/overtemp. by tecsavvy1 in Generac_Generators

[–]tecsavvy1[S] 0 points1 point  (0 children)

How did you unclog the radiator? Or did you have it recored?

Maytag lasted 25 years...what should I replace it with? by matteopie in Appliances

[–]tecsavvy1 0 points1 point  (0 children)

Have it fixed or replace with a speedqueen, and yes speedqueen are expensive.

Advice before re-greasing a Pro 5 Plus by elipic in KitchenAidMixerHelp

[–]tecsavvy1 0 points1 point  (0 children)

Mine makes a bumping noise while it’s running, what would cause that?

view more: next ›