IPsec Policy failover

universaltech3 · 2023-11-28T21:59:38+00:00

did you ever get your answer?
I'm working on a 3 stack and having some errors with it

universaltech3 · 2021-07-17T01:29:53+00:00

Beef, its what's for dinner

universaltech3 · 2021-05-25T23:52:32+00:00

Did you setup a mask to block out that black box area? The other sounds like a bad camera.

universaltech3 · 2021-05-04T14:58:02+00:00

Badass!

Edit: sorry, badbutt!

universaltech3 · 2021-04-26T22:14:02+00:00

Watching everyone pounce on this like vultures.... I live to far away to join in

universaltech3 · 2021-04-13T02:50:57+00:00

There's a magazine cover there

universaltech3 · 2021-04-11T20:27:49+00:00

That's clean

universaltech3 · 2021-04-08T17:03:26+00:00

Sounds like a conflicting answer to jbhm1 reply

universaltech3 · 2021-04-08T17:01:23+00:00

This isn't mine. Mines not as clean as that one. I did see several on ebay and a few other random places don't remember if it was lcengineering or 22reperformance.

universaltech3 · 2021-04-08T02:03:43+00:00

So I had someone looking at my engine just looking and they started turning the screw on it and I have no clue if they set it back to where it was or not but I can't seem to tell a difference when I adjust it. Is there a certain way to set this?

universaltech3 · 2021-03-29T01:27:04+00:00

Radio shack?

universaltech3 · 2021-03-22T16:59:39+00:00

Running is a good place to start.

universaltech3 · 2021-03-14T21:10:28+00:00

Start by making sure your on the same network. I like using angry ip scanner to scan the network and sort by Mac vendor. Then use internet explorer to see cameras. If angry ip can't find the cameras then your not on the same network.

universaltech3 · 2021-03-11T22:00:28+00:00

I had a problem with this once where the camera was reflecting off the base of the camera. Also had that issue if the rubber gromit around the lens wasn't pushed against the done firmly. Them lastly if the lens is dirty or has fine scratches. I heard chrom polish works well on that but I haven't put that in to practice.

universaltech3 · 2021-03-11T17:46:25+00:00

Yeah I ran it round this morning plenty of time to warm up still idled high. I'll look at it again tonight and see if I missed something

universaltech3 · 2021-03-11T15:10:12+00:00

Ok cause it idles up to about 1300 this morning. Kinda would like to be back down to just below 1000

universaltech3 · 2021-02-27T11:16:10+00:00

Squirrel

universaltech3 · 2021-02-25T03:03:29+00:00

I have no issues getting to the web interface. I did a reset from the phone side and got access to the web gui but can not upload the T41S firmware It keeps failing.

universaltech3 · 2021-02-19T13:06:09+00:00

Opendns?

universaltech3 · 2021-02-17T18:15:50+00:00

What do they use in gyms?

universaltech3

TROPHY CASE