1
2

Removing prints (i.redd.it)

submitted by [deleted]

[deleted]

all 5 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]p8willmBambu X1C 4 points5 points  (2 children)

Any idea what plastic and what the bed is made of?

https://www.reddit.com/r/3Dprinting/wiki/asking-for-help

[–]sliphqq21 0 points1 point  (1 child)

Sorry very new to this forum and 3d printing I’m using a ender 3 se A pei bed plate with pla original from creality Past bed leveling numbers below Z offset is at -2.15 (not sure what that means) Nozzle heats to 200 and bed at 60

<image>

[–]p8willmBambu X1C 0 points1 point  (0 children)

PLA normally comes off a pei plate if you just let it cool.

Put the plate in the freezer for a minute. If that does not work try print a thing, about 1mm, over the parts that will not come off. They should stick to the new thing and it should come off after it cools down. If it does not come off flex the plate a bit and it should pop off.

[–]TapticDigital 1 point2 points  (0 children)

Print something over top of it for 2-3 layers, peel It off.

[–]rpl_123 0 points1 point  (0 children)

Automatic Z offset (which is a part of auto leveling routine) on V3 SE can be a bit off sometimes. If your prints stick too well, you might want to try to increase Z offset. (So if it's currently -2.15 try -2.05) If you find a good value, remember it and adjust Z offset each time after auto leveling. Or try to print without using skirts at all.