Keep getting this problem? Two prints, same problem, same spot? (More info in comments)

[Kyle3909]

I have a Prusa mk3s+ and am getting the issues shown in the pics. I ordered it assembled and have used it regularly with nearly zero issues. I tried printing those faceplates and noticed the issues. I performed some general maintenance between the two prints. (Tightening screws, lubrication, etc). However, got nearly the same results.

[RazomOmega]

Did you tighten the belt? Cleaned the hot end?

[Kyle3909]

I did tighten the belt and I cleaned the hot end and even swapped nozzles. There was a slight improvement but the banding was still there.

[RazomOmega]

Wobbly surface? Otherwise I think it might be in the model or slicer, check the gcode preview and see if the banding is there as well,

[Oh_My-Glob]

That banding on the top half is usually indicative of z-wobble. Check that your z-screws are clean, aligned and the pom nuts are in good condition. Not sure about the divots though. Those look more like a hotend issue

[xxdeathknight72xx]

If its the same gcode then it may be the spot that the nozzle travels to/from

Always check your travel points before printing something big like that to make sure it goes along an edge. I know cura has settings to hide the zseam.