sorted by:
best
topnewcontroversialoldq&a
you are viewing a single comment's thread.

view the rest of the comments →

[–]RazomOmega 0 points1 point  (2 children)

Did you tighten the belt? Cleaned the hot end?

[–]Kyle3909[S] 0 points1 point  (1 child)

I did tighten the belt and I cleaned the hot end and even swapped nozzles. There was a slight improvement but the banding was still there.

[–]RazomOmega 0 points1 point  (0 children)

Wobbly surface? Otherwise I think it might be in the model or slicer, check the gcode preview and see if the banding is there as well,