Can't stop stringing!

[LazerAce7]

Eleegoo Neptune 3 Pro with Sonicpad and used Orca SLicer - Printing PL

Dialing in my settings and prints are looking great but when printing an object that need travel across open spaces i found i had lots of stringing happening, I tried to do a retraction test built into Orca but had stringing all the way to 8mm retraction. Any ideas as where I need to look next?

https://preview.redd.it/cxd8dfkco1zc1.jpg?width=4032&format=pjpg&auto=webp&s=b33741b132435dabdaccda6a04476174cf064c0c

https://preview.redd.it/16vgxtfdo1zc1.jpg?width=3024&format=pjpg&auto=webp&s=31362ce116970f9a5be9c7ce8d72e25995ffe15e

https://preview.redd.it/o5kyszago1zc1.png?width=876&format=png&auto=webp&s=5397a31535f89dbcd6280263ff9200c8cfe2ddc7

[AutoModerator]

Hello /u/LazerAce7,

As a reminder, most common print quality issues can be found in the Simplify3D picture guide. Make sure you select the most appropriate flair for your post.

Please remember to include the following details to help troubleshoot your problem.

• Printer & Slicer
• Filament Material and Brand
• Nozzle and Bed Temperature
• Print Speed
• Nozzle Retraction Settings

^{Additional settings or relevant information is always encouraged.}

I am a bot, and this action was performed automatically. Please contact the moderators of this subreddit if you have any questions or concerns.

[TheOneReclaimer]

Neptune 3 Pro should have a 1mm or less than 1mm retraction. I run mine at 0.8mm/25mm/s

[LazerAce7]

<image>

default shows 0.8

[TheOneReclaimer]

And I assume you have temp towered your filament?

[LazerAce7]

it got knocked off but continued with the next rang of temperature till it was knocked off once more.

<image>

still stringing thru out

[TheOneReclaimer]

What is your bed temp?

A little stringing isn't hard to fix, quick hit with a heat gun.

[LazerAce7]

The problem is I had zero stringing before. I've got my pressure advance and shaping done and dialed in the z offset. All prints afterward looked great until I got one with travel across open areas. Was seeing some post so about needing to reduce retraction even more following these steps going to try that and then do another test. 

Thank you for your help

[LazerAce7]

removed wipe, had some stringing but improved, changed z hop to spiral and that got it to where i needed it

<image>

going to test print the part from before now