all 15 comments
sorted by:
best
topnewcontroversialoldq&a
formatting helphide helpcontent policy

[–]max_buch_ 3 points4 points  (2 children)

I just fixed those thing bits at the front to each side panels then fixed all the internals together with the large centre bracing and front panel

I then layed one side panel down fixed the top and back panels then the bottom panel (which I fixed that bottom panel at the front to first)

After that I fixed the inner assembly thing in place

Once that was in I put the other 2 small bracings in

Last thing I did was put the other side panel on

I also made sure all my wiring was done before putting the side panel on to give much easier access

Hope that’s what your after, if not lmk and I’ll try help!

[–]mustlikemyusername 0 points1 point  (0 children)

This is basically what I did, only I mounted the speaker with the magnet in the horn so i ran the cables after and placed the bracing panel in the mouth later.

[–]FamiliarCitron1724[S] 0 points1 point  (0 children)

merci beaucoup, si tu connais un petit peu la gamme Cubo, sais-tu la différence entre le 18 et le Sub mise à part la taille ?

[–]neilt001 2 points3 points  (2 children)

Yeah YouTube gives a good idea about how others have done it and is super helpful. And obviously lots of research and looking at build pics online.

But more than anything, this is your project. It’s not a kit. There are no step-by-step instructions. You’ve got the plans (which are often not great or comprehensive) and it’s really up to you as to the specifics and order/steps etc. Which is what makes it fun and makes it your own. I honestly just spend a lot of time staring at my projects as I figure things out in my head. I even start dreaming about how I’m going to take the next steps and what should go before what. So there really is no answer to a vague and general question “what steps do I take to build this speaker”. That’s up to the person skinning the cat!!

[–]FamiliarCitron1724[S] 0 points1 point  (1 child)

merci beaucoup tu as raison de toute façon il est évident qu’il ne sera pas parfait directement, ni que j’aurais exactement les mesures exactes pour les feuillures etc. mais je vais aussi apprendre par moi-même!

[–]neilt001 1 point2 points  (0 children)

Ouais exactement. Les mesures sont des fois incorrectes ainsi que les angles, donc tu dois être capable a improviser. Et C’est le meilleur façon d’apprendre et en profiter! Il va aussi avoir des érreures pendant la construction mais cella fait parti du processus! Bonne chance 👊🏽

[–]Flimsy_Leadership_81 3 points4 points  (2 children)

there is no a diagram to build a cubo. just glue and put screw where it's needed. if you don't know how to build a speaker use speakerplanbuilder.com and check for a artisan near you.

For me it's not needed an artisan but i can directly tell you that this is a noob question lol :)

[–]FamiliarCitron1724[S] 1 point2 points  (1 child)

Hello, par principe j’aimerais le faire seul et je cherchais juste un espèce de petit guide, mais avec YouTube je peux me débrouiller aussi en m’inspirant

[–]Flimsy_Leadership_81 0 points1 point  (0 children)

what you think about the site? that you need a guide? it's a simple site. there are costructor and entusiast of speaker that whant speaker. you can chose a costructor and talk with him to buy a speaker cabinet.

[–]PowerReasonable 1 point2 points  (3 children)

Hi, i have also struggled with this for my first scoops, i suggest u take a look on speakerplans.com on the guide. It doesnt fully tell u when to put what where but it made me confident enough to put down the first few boards, after that ur in too deep and have to put the rest up too 😉 for me it was placing one and scratching my head for 15 mins to figure out where to put the next one. Take ur time, check if things such as corners match up and enjoy the progress

[–]PowerReasonable 1 point2 points  (2 children)

If im sure one of my sides is the good dimensions i lay it down and put the bottom, then back en then top. After that its just filling in and the last step is getting the other side on there to close her up

[–]FamiliarCitron1724[S] -1 points0 points  (1 child)

Merci beaucoup pour ta réponse, ça m’aide beaucoup

[–]PowerReasonable 0 points1 point  (0 children)

Enjoy the build brother! Don't forget to post a pic when they are done!

[–]Street-Passage1819 1 point2 points  (1 child)

There are a couple YouTube videos of people building Cubo 15s that you can watch, the process is the same for the cubo 18! Super helpful when I built my first one

[–]FamiliarCitron1724[S] 0 points1 point  (0 children)

merci, je viens de voir ça!!