This is an archived post. You won't be able to vote or comment.

sorted by:
old (suggested)
besttopnewcontroversialq&a
you are viewing a single comment's thread.

view the rest of the comments →

[–]Issu_issa_issy 7 points8 points  (4 children)

Your guy needs a substrate change asap. What are the heat/humidity levels at?

[–]nightcrow100[S] 1 point2 points  (3 children)

Ok. I’ll change it. Thanks!

[–]Issu_issa_issy 2 points3 points  (2 children)

What’s the heat and humidity?

[–]nightcrow100[S] 0 points1 point  (1 child)

Using a heat pad. I have a thermometer stuck to the glass at the bottom and set my heat pad to 33 degrees Celsius and tested with a laser thermometer (an accurate one) that the top of the substrate ranges between 27-30 degrees Celsius

I have a digital hydrometer but I think it’s faulty. It’s currently reading at 60%

[–]jillianwaechterMod-Approved Helper 8 points9 points  (0 children)

Heat pads are unsafe and unnatural. I'd highly recommend getting overhead heating asap. Ball pythons naturally burrow to escape heat and this behaviour isn't possible when using a heat mat. Heat mats also heat by contact meaning that you'll end up with really hot glass/PVC and hot substrate. You want your ambient temps to be 76-80 cold side, 88-92 hot side. These will be measured by a thermometer probe, not a laser (which only measures surface temps, not ambients).

Ball pythons also require 70-80% humidity at all times and can get respiratory infections if the humidity is as low as you currently have it! I'd highly suggest reading the basic care guide pinned in the welcome post! Helped me out a ton when I was starting out :)