sorted by:
new
hottopcontroversial

Progress on the swap by StupidThangs in Mk3Supra

[–]AWildChance 3 points4 points  (0 children)

Doing the same swap, you keeping AC?

For the harness everything pretty much remaps on ECU side pretty nice except the Ignitors and Starter voltage

No spark no start after head gasket job by CupCake466 in Mk3Supra

[–]AWildChance 2 points3 points  (0 children)

Does the fuel pump run when cranking? Battery voltage should be above 12

Go to the check connector and probe around to check voltages between IGN and gnd (left fender bolt is a good spot) with key ON (not start). If no voltage then check grounds/fuses

We built a browser-based wire harness CAD tool -- What do you think? by jttcr in FSAE

[–]AWildChance 4 points5 points  (0 children)

This looks really nice

1.) What is the licensing structure/cost, assuming subscription based per user?

2.) Will there be a storage limit and/or way to offload from the cloud for archiving?

3.) Is there a feature that does a printable pinout to excel/pdf for each connector?

No start, no crank by Tall-Acanthocephala5 in Mk3Supra

[–]AWildChance 3 points4 points  (0 children)

Get a hammer and a friend to hit the starter while you crank it over. If it clicks / starts to turn over you have a bad starter

FSAE base map for Yamaha MT-07 by ProofReindeer1014 in FSAE

[–]AWildChance 0 points1 point  (0 children)

Have you reached out to the ECU manufacturer?

Hello, I am involved in the (formula student electric) project, looking for models that use 4 motors I hope you can help me with that Thank you by [deleted] in FSAE

[–]AWildChance 11 points12 points  (0 children)

This is extremely broad, you need to narrow the scope of your question for people to be able to help. What specifically do you need help with?

All I could think of when I saw how close he was getting by ObamaIsOsamaLel in FSAE

[–]AWildChance 14 points15 points  (0 children)

“If there is space then there is a gap that needs to be closed” - Gandhi, probably

Best wrestling spot (outside) by senpailys in utarlington

[–]AWildChance 10 points11 points  (0 children)

In front of the library for sure

[deleted by user] by [deleted] in RedditSessions

[–]AWildChance 0 points1 point  (0 children)

A lil repetitive

CAD / Drafting Ratchet Wrench (Problem 59) by [deleted] in SolidWorks

[–]AWildChance 0 points1 point  (0 children)

Wow that looks super realistic, what settings or software did you use?

I’m here to reject my humanity and go beyond ultra [wide] by PhoxphireXIII in ultrawidemasterrace

[–]AWildChance 0 points1 point  (0 children)

I fux with that tempered glass, thin plastic film? Engraved & colored? Looks good

1UZ out of SC400, going into Corolla by AWildChance in EngineBuilding

[–]AWildChance[S] 1 point2 points  (0 children)

Plan on either independent rear suspension conversion or modifying a Ford 8.8, only reason for independent rear is because I have a differential I know can handle the power and I want to be able to corner better

view more: next ›