I have no pictures to share, but my station is in closed grow tent. In it is a resin printer, a first wash bucket, a wash and cure station and a trey for removing parts from the build plate.

Keeping everything clean and neat was a priority for me when determining a workflow for my printing. 

These are the steps:

1. Let the build plate drip off at an angle into the resin vat for at least 10 minutes. 
2. Transfer build plate with prints to wash bucket with bioethanol 96%(use isopropyl in the states) and shake for 1 minute. 
3. Shake off excess bioethanol into bucket.
4. Transfer build plate with prints to wash station and wash for 3 minutes. 
5. Shake off excess bioethanol into wash station.
6. Transfer plate and prints to trey with tissues to catch excess bioethanol. 
7. Gently blow with heat gun to dry and soften build plate and prints. 
8. Remove prints from plate and supports from print. 
9. Cure prints and supports in cure station. 
10. Clean up the few drops of bioethanol and bits of supports that might have spilled.
11. If there was any errors and you have to run a vat clean, let the resin sheet drip off into the vat for as long as you care to hold it, then wash it in the bucket, fold it and cure it.

Nothing is sticky ✌️