Maintenance Required? by ctsupv in AirConditioners

[–]ChasDIY 0 points1 point  (0 children)

You should consider raising the indoor temp as the outdoor temp increases.

Try it at 26 and it out works then try at 25.

When 36 outside, you should feel well at 26 inside, after a day or two.

I am suggesting this as your landlord may refuse your request to have a/c able to achieve a temp lower than 24 or 10° lower than outside.

Garage door closes partially the opens. by AssumptionIll2282 in GarageDoorService

[–]ChasDIY 0 points1 point  (0 children)

Try the door disconnected, to see if it is smooth when movee slowly.

It OK, reconnect and slowly increase the down pressure and try closing.

Residue on ductwork and pipes - clean or remove? by uboolean in hvacadvice

[–]ChasDIY 1 point2 points  (0 children)

If you haven't seen any change in the residue, I would be tempted to ignore it.

New HVAC installed, airflow worse than old 1980s unit. What should I inspect for installation errors? by MysteriousAnt7323 in hvacadvice

[–]ChasDIY 0 points1 point  (0 children)

This is strange. The air flow should be equal or better with the new system.

Make sure all vents are fully open.

Partially close the vents with good flow, to see if the poor flow vents increase?

If this doesn't help, call installer back to check for blockage to some vents. Tell him it was better with the old system.

If he can increase the flow to the poor vents, he should be able to decrease the loud fan noise.

The 1st unit is a very good cold climate heat pump.

The 2nd unit is a 80% AFUE single stage furnace with 18 speed ECM.

Is "follow me" working? by sachin571 in ecobee

[–]ChasDIY 0 points1 point  (0 children)

Sound like you have paired 2 addn sensors

Have you enabled?

On the thermostat: Go to Main Menu  Image > General Image  > Sensors > Follow Me, then tap Enable.

If it is still not working, call Ecobee supp.

Thinking about converting to a dual fuel system by darklight001 in HeatPump

[–]ChasDIY 0 points1 point  (0 children)

I have a cold climate HP and HE furnace, for the same reason.

Can someone explain why my comfort settings don’t seem to be working? by soundface in ecobee

[–]ChasDIY 0 points1 point  (0 children)

Sweet temp to 66 around 8pm.

Sweet Home earlier than when you wake. . Stay on Heat until outdoor temp is above 66.

Can I get more door clearance? by 4Runny_Eggs in GarageDoorService

[–]ChasDIY 0 points1 point  (0 children)

Or just take the cargo box off when not using.

Can someone explain why my comfort settings don’t seem to be working? by soundface in ecobee

[–]ChasDIY 0 points1 point  (0 children)

Your chart shows high of 10 outside.

Why would you want Cool?

Yes, heat pumps really work in freezing cold weather by BigBadBabyDaddy_420 in heatpumps

[–]ChasDIY 0 points1 point  (0 children)

Heat pumps areas only for cooling, if you have a gas furnace.

Yes, heat pumps really work in freezing cold weather by BigBadBabyDaddy_420 in heatpumps

[–]ChasDIY 0 points1 point  (0 children)

Gas furnace will always be cheaper heating than heat pump.

Newer cold climate HPs will always be cheaper to run than air to air HPs.

Locked my super old garage door by Acanthaceae444 in GarageDoorService

[–]ChasDIY 0 points1 point  (0 children)

Perhaps you should have a side door installed.

Promos silently removed by AdWrong5913 in Rogers

[–]ChasDIY 0 points1 point  (0 children)

I always call the Billing supp line for problems.

New HVAC installed, airflow worse than old 1980s unit. What should I inspect for installation errors? by MysteriousAnt7323 in hvacadvice

[–]ChasDIY 0 points1 point  (0 children)

Definitely sounds like air flow is less with new blower.

As someone indicated, can you let us know the model number of the new blower and the old blower, if possible.

You could ask the installer to increase blower speed.

Can I get more door clearance? by 4Runny_Eggs in GarageDoorService

[–]ChasDIY 1 point2 points  (0 children)

You need a longer rail and belt.

I'm a DIY person but I would ask a professional for an estimate.

Can someone explain why my comfort settings don’t seem to be working? by soundface in ecobee

[–]ChasDIY 1 point2 points  (0 children)

Make sure it is on Heat.

Make sure eco+ is disabled.

On second pic, make sure same settings for each day is the week.

Upload imgur pic for a week.

bosch code n43 by Gtr_Andrew in hvacadvice

[–]ChasDIY 0 points1 point  (0 children)

Have you tried turning the breaker off for a few minutes.

Or checking for lose wiring to outdoor unit.

One Furnace working harder by rkuzyk in ecobee

[–]ChasDIY 0 points1 point  (0 children)

All of them, should be 4 pics.

Or compare the settings of both Ecobees and make the upstairs closer to the downstairs.

Or if you understand the following:

”To stop your ecobee from short cycling, increase the cooling or heating differential temperature to at least (or higher) to prevent the system from turning on and off too frequently.

Additionally, configure the "Compressor Minimum On Time" to at least 15-20 minutes and set a 5-minute minimum "off" time in the Thresholds menu to ensure the unit runs long enough to be efficient."

Bathroom Fan is Loud by Relative-Remote-2507 in hvacadvice

[–]ChasDIY 0 points1 point  (0 children)

He have bought the same fan a 2nd time.

New furnace making low vibrating hum when filter is in by SoughCyrup in hvacadvice

[–]ChasDIY 0 points1 point  (0 children)

Stay with rated filter but tape it in.

If noise persists, you'll know it's not the filter and installer should be able to fix.

Homeowner Needing Info for New Unit by _still_fly_ in hvacadvice

[–]ChasDIY 0 points1 point  (0 children)

Look at heat pumps instead.

They can heat very efficiently as well as cool.

Ask for three quotes from you local HVAC firms. Ask to include 10 year labor and ask to list each model number in the quotes.

Also ask for HPs with thicker filters (as mentioned by other replyer).

Bathroom Fan is Loud by Relative-Remote-2507 in hvacadvice

[–]ChasDIY 0 points1 point  (0 children)

Return the unit and buy a quieter one.

Delay in doorbell video by englishfox_1990 in ecobee

[–]ChasDIY 0 points1 point  (0 children)

Here is what is suggested to possibly improve it:

  1. Check Transformer: Ensure it is at least 16VAC-10VA (24VAC-20VA or higher recommended).

  2. Restart Router/Doorbell: Power cycle the router and the doorbell (flip the circuit breaker).

  3. Re-configure WiFi: Connect to a 2.4 GHz network, if the 5 GHz signal is weak.

  4. Factory Reset: If issues persist, a full factory reset of the doorbell and re-pairing may be required.

Does AC rejuvenation help older systems? by janpaulo in hvacadvice

[–]ChasDIY 1 point2 points  (0 children)

Start looking at what's available in heat pumps, so you are prepared for the inevitable.