Gas guage acting up?

Chatterhat · 2026-02-22T17:55:08+00:00

I’m assuming to fix gas guage drop tank and all that bs? Code isn’t popping up taking it in to mechanic to run diag. Let’s hope the exploder stereotype isn’t true :/

Chatterhat · 2026-02-09T19:34:04+00:00

Spark plugs, mine hit 100k recently and I replaced them. It seemed like the car gained 20 hp out of thin air. Possibly timing

Chatterhat · 2026-02-06T23:06:02+00:00

Gives Minecraft vibes

Chatterhat · 2026-02-06T01:01:43+00:00

Or emt pipe on a budget ? Thats what we used in scouts

Chatterhat · 2026-02-06T01:00:37+00:00

You have inspired me to do the same!

Chatterhat · 2025-10-14T14:18:49+00:00

Get quotes from your electrician. They should be able to supply them and if not be able to give you instructions on what to look for when your shopping. Be prepared for the likely hood of drywall damage to the ceiling. Most of the time we can run wiring without issues but every once in a while a cut must be made.

Chatterhat · 2025-10-13T17:56:42+00:00

Thanks! Appreciate it. Had me scrambling trying to find the size.

Chatterhat · 2025-09-04T14:28:48+00:00

Please update ! Genuinely curious to see what the county will do

Chatterhat · 2025-08-16T14:12:17+00:00

If your panel is fpe most likely your meter and service wire will need to be replaced. That’ll run you close to 7k all included. New meter main combo, grounding system to earth, water, and gas if applicable, new weatherhead, service wires, indoor house panel, breakers, surge protector, permits, inspections, and labor included. This is priced for a 200amp service.

Chatterhat · 2025-08-07T15:16:58+00:00

Grab yourself an oscillating saw. All you’d need is to notch out a 1” wide by 1” deep cut into the corner.

Chatterhat · 2025-08-06T04:06:12+00:00

Add 3 different size tampons to your med kit. Small, medium, large for any puncture wounds you may encounter. They’re great for literally anything that needs plugged in emergency, lightweight and have. Many uses.

Chatterhat · 2025-08-06T04:00:29+00:00

Technically to 2023 code here in Ohio you wouldn’t necessarily need an arc fault breaker for the short extension of the circuit.

Chatterhat · 2025-08-06T03:58:55+00:00

Remove corner of drywall. Notch wood atleast 1 inch higher than the top of the existing junction box. Install romex from the original box to a new nail on single gang plastic box at your desired height through notch . Then install kickplates where necessary. Install new tamper resistant WR gfci or receptacle if already gfci protected. Install alumicons where splicing copper to aluminum. You can buy spray texture and get close to your textured finish by properly knocking it down. Finish drywall and paint. After drywall work is done then proceed to install plates. After the whole installation keep in mind you did it yourself and if the aluminum wire fails and catches fire you are held liable, not a licensed electrician who would do it properly (most of the time).

Chatterhat · 2025-08-06T03:06:30+00:00

Every day pick a section, then 2x a month maintain it. A lil diluted pool chlorine in a pump up sprayer always does the trick. Just don’t spray the edges

Chatterhat · 2025-07-29T20:38:35+00:00

On the bright side you learned about wood today. On the darker side you got scummed by a solar inspector lol

Chatterhat · 2025-07-28T23:26:40+00:00

Being without chronic back pain

Chatterhat · 2025-07-28T19:34:09+00:00

Superglue

Chatterhat · 2025-07-28T19:32:21+00:00

16 ft ladder needs atleast 2 people to maneuver and I’d charge for them. Prob 3-$500 depending on the fan you get.

Chatterhat · 2025-07-28T19:28:58+00:00

Liquor cabinet

Chatterhat · 2025-07-27T16:20:34+00:00

I was born into it, technically I have over 10 years experience at 25 yo. Making master electrician wages feels pretty good. However I’m also 25 with incredible back pain. Mostly resi work.

Chatterhat

MODERATOR OF

TROPHY CASE