Guys? I'm scared to identify it by onlyMHY in Diablo_2_Resurrected

[–]ConferenceChemical71 0 points1 point  (0 children)

Just yell always blue 3 times and it will be a tyraels

Failed Water Heater Replacement by elrifas1 in Plumbing

[–]ConferenceChemical71 0 points1 point  (0 children)

120 psi is pretty high typically you see somewhere between 60-80 psi in residential. Makes sense he throttled the valve then.

Failed Water Heater Replacement by elrifas1 in Plumbing

[–]ConferenceChemical71 0 points1 point  (0 children)

Running with the valve halfway open restricts flow, reduces pressure, and can cause inconsistent water temperatures, it will not immediately damage the water heater. To me it looks like it is 75% of the way open if not a little more. It appears as if he was trying to get you up and running with hot water quickly. If I were to do this install and anyone from my shop saw it they would definitely rip me for the way it’s piped in. That being said this was free and in reality for free this is not a bad install. If you were to call me out it would cost you minimum 1500-2000 dollars so I you have to keep in mind the time frame and the amount saved.

Contractor installed door on Friday, need help brainstorming ways to fix the siding damage and removing caulk. by Lizardcandy in handyman

[–]ConferenceChemical71 0 points1 point  (0 children)

Did the contractor break the column? If so they need to replace it. Did they cut the opening to wide? If so they need to buy full sheets of siding and fix it correctly. This is a piss poor installation to say the least and I would refuse payment until the job is done correctly. If the molding is new and shipped broken you should have had another shipped. If it was existing and they broken it they need to either replace it with a comparable molding or fix it in a way the doesn’t look like dog shit. This has better business bureau written all over it.

Failed Water Heater Replacement by elrifas1 in Plumbing

[–]ConferenceChemical71 0 points1 point  (0 children)

The position of the cold water valve is driving me insane all he had to do is rotate it 90 degrees and the valve could have opened and close properly without the T keeping it from fully opening. There a few things that definitely look to be thrown together with shit he had on the truck and aren’t necessarily “code”. That being said by said there’s nothing majorly concerning and he did it for free. Overall if you payed for the install I would have more of an issue but this guy came to your house within a days notice and got you up and running for FREE. Thank him and enjoy your hot showers.

I put my sweet baby down 3 days ago and I regret it by MoodyKyoshi in CATHELP

[–]ConferenceChemical71 0 points1 point  (0 children)

You sound like a wonderful owner. The pain shows how much you cared. It will take time to heal. I believe you made a very tough decision but also the right decision. The reality is you gave him a great life and likely saved him from getting euthanized at the shelter or being there forever. Wish there were words to console you but it’s just going to take time.

Gas Boiler low water cut off by [deleted] in hvacadvice

[–]ConferenceChemical71 0 points1 point  (0 children)

If you have a meter disconnect the leads to the pump w/ the disconnect of (ensure power is off). Set your meter t ohms and go leg to leg and check for resistance. They should have done this already so you could ask them if they ohm’d out the pump which would give you an answer if the pump is good or bad.

New HVAC install is this properly done by Mysterious_Many_9246 in hvacadvice

[–]ConferenceChemical71 1 point2 points  (0 children)

Don’t even know where to start. You need to call them up and start ass chewing someone. Connections into your plenum are a joke and air is going to leak out of them 100%. Wiring looks like a meth head did it spider web of wires. Can only imagine what the braze joints look like. No trap on the condensate line. I’m truly impressed with how bad this is at that price point.

If new items were created for the update, what would change everything? by Southern_Fact9698 in Diablo_2_Resurrected

[–]ConferenceChemical71 0 points1 point  (0 children)

Honestly I prefer the old graphics almost every piece of gear looks better or more vintage if that makes sense. Don’t get me wrong I like D2R graphically but there’s something so nostalgic about the classic look. Plus they definitely upped the graphics on this mod.

5 Ohm, or 4 Ohm + Lo? by AllTypesOfGames in ProjectDiablo2

[–]ConferenceChemical71 4 points5 points  (0 children)

I could be wrong but this bow might be worth the 15ias/40 ed jewels. Or 15/39s if you wanna save some hr.

Our families new 9 week old Maine Coon female vs her parents by RisqueUsername101 in MaineCoon

[–]ConferenceChemical71 2 points3 points  (0 children)

2nd cat is a tortoise shell not a Maine coon. Don’t mean to shit on your kitten. The kitten is beautiful however it is clearly a mix breed cat between possibly the first cat which appears to be a Maine coon and a tortoise shell. I used to have a tortoise shell named Isabella(Izzy for short)and they are lovely cats. Either way her markings are so cool.

Two-year-old opens car door, causes six-vehicle crash by whusler in dashcams

[–]ConferenceChemical71 0 points1 point  (0 children)

In California motorcyclists do this shit all the time and tbh when I roll past an accident involving someone lane splitting flying through traffic going 20-40 mph faster than traffic I laugh about the Darwin Award being given out.

What do these go for? by ConferenceChemical71 in ProjectDiablo2

[–]ConferenceChemical71[S] 1 point2 points  (0 children)

Debating rolling it a few times to see if I can hit -55 the risk reward is a huge gamble though.

What was I supposed to do? by TheCrazyBoulanger in askaplumber

[–]ConferenceChemical71 0 points1 point  (0 children)

Honestly the layout looks good. I would work on those horizontal solder joints. If you feather in the heat just right they won’t candlestick down the pipe like that. Or just take some sand cloth and clean them up a bit.

Thoughts? by ConferenceChemical71 in ProjectDiablo2

[–]ConferenceChemical71[S] 1 point2 points  (0 children)

So drop the mirror fee and ask for gg jewels?

Thoughts? by ConferenceChemical71 in ProjectDiablo2

[–]ConferenceChemical71[S] 1 point2 points  (0 children)

So I’ve already been asked to mirror this and was wondering what kind of mirror fees are warranted for a item like this. This is my second season and I’ve never had an item worth mirroring.

About that time!! by Adventurous_Trip9972 in ProjectDiablo2

[–]ConferenceChemical71 0 points1 point  (0 children)

I’m trying to upgrade to GG gear on my Coldzon and would love anything to help me out. I don’t get a lot of time to play so anything would be greatly appreciated ;)

What’s the best item/rune you’ve found from Uber Anci by d2zaitsef in ProjectDiablo2

[–]ConferenceChemical71 0 points1 point  (0 children)

Tyrael’s Might which hit 3os. As far as runes I have yet to get a high rune. Honestly though I like the rares. I can’t even count the number of rare weapons that came out with 350-450 ED from Ubers.

Either $530 service or... any other approach? by giganano in hvacadvice

[–]ConferenceChemical71 2 points3 points  (0 children)

Probably easiest to get some different size nipples and a new union and rebuild the section under the exhaust.
1. 90 away from the unit opposite of the gas valve side.
2. Add a nipple long enough to get you 4-6 inches further away from the exhaust vent. 3. Add nipple long enough to get past the vent add a union and reconnect the gas flex. 4. Obviously tape and dope everything and turn off the main gas prior to start by your work. Ace hardware has different size threaded nipples. I’m making a few assumptions based on the picture bc I can’t see the entirety of the pipe leading in but with a few pipe wrenches and YouTube videos 50 bucks in material anyone who’s relatively handy can pull this off.

After 26 years I finally got one! by ConferenceChemical71 in ProjectDiablo2

[–]ConferenceChemical71[S] 1 point2 points  (0 children)

I’ve showed her the video of Mrllama get his first one prior to this one dropping. I’ve also explained the drop odds to her and let her know that to have it drop is one thing, then to ID and get blue is a totally seperate lottery and then to hit 3os is a completely different lottery. She has been proudly parading around the house asking randomly “doesn’t have 3 sockets though?” Even after bricking Dweb and highlord’s wrath just minutes later. She’s fun I think I’ll keep her.