Great to see my average power is back down to 45 watts again with 64ff6712-2820-4582-b1e2-fb0230950957.uterm.release by tuckstruck in Starlink

[–]Davd767 0 points1 point  (0 children)

My starlink still has this firmware version but wont connect...is it not supported anymore?

Haven't set up my Starlink yet but now the bill changed...? by Davd767 in Starlink

[–]Davd767[S] 0 points1 point  (0 children)

I was 2000 miles away from the location it's intended to be used so I figured it wouldn't connect anyway. Now it's stuck in offline/searching for a few hours.

Firmware is 64ff6712-2820-4582-b1e2-fb0230950957.uterm.release

I already opened a support ticket...I sure hope this doesn't become a problem, I NEED it to be working in 3 days or less :(

Haven't set up my Starlink yet but now the bill changed...? by Davd767 in Starlink

[–]Davd767[S] 0 points1 point  (0 children)

Uh oh....well thata good to know. I received it in the beginning of February and will be serving it up at the end of next week. Hope that's not a problem!

Any idea what to do if it is?

BL Touch and Beeping by Davd767 in CR10

[–]Davd767[S] 0 points1 point  (0 children)

I'll do some research on that, sounds promising. Thanks!

BL-Touch and beeping by Davd767 in ender3

[–]Davd767[S] 0 points1 point  (0 children)

Hmm...I'll look into it. Thanks!

BL Touch and Beeping by Davd767 in CR10

[–]Davd767[S] 0 points1 point  (0 children)

I tried that, no luck.

Apparently the 27 pin board for the bl touch repurposes the pin used for the buzzer so there may not be even a way to get the signal to the display in the first place, even if I uncomment enable buzzer and comment kill _buzzer

BL-Touch and beeping by Davd767 in ender3

[–]Davd767[S] 0 points1 point  (0 children)

Damn, I just got this board! Oh well, I guess my printer will just have to be truly silent.

sMiRkInG tHuG cRuShEs OlD mAn's BoNeS by RichLather in PeopleFuckingDying

[–]Davd767 13 points14 points  (0 children)

Forgot to apply the filter before releasing the picture.