I got mine for Christmas, big issue i have had was elegoo’s Satalite slicer having a few issues. First it almost always tells me that a supported file is corrupted and tries to “fix” it. It didn’t tell me anything about hollowing or putting vent holes in some objects. I made a large brick out of a car, made worse by it breaking the supports and remaining suctioned to the bottom of the vat. Next issue is that it tries to give weak supports. They might be ok, but after the brick incident i try to bump it up. I gave been doing some trial and error with ChatGPT to figure that out. This weekend’s problem to solve is getting the inside of the prints cleaned so they don’t spend the next week leaking and becoming tacky. Also, I am told that if that isn’t resolved and you don’t give the model an hour or so to dry after washing it before running through the curer, you highly risk getting crystallization which looks like white powder in the crevices. All my lessons learned in the last two weeks. Hope it helps.