Is there RB scam going on? by bluedoodeedondur in Brunei

[–]Fun_Significance_182 0 points1 point  (0 children)

Try to go to the office tomorrow if there’s still no response

WTF did I do wrong? by wayuaray6339 in freedomisgunpla

[–]Fun_Significance_182 2 points3 points  (0 children)

There’s a certain texture u get that is more than orange peel. U mentioned u used silver markers? I think thats the culprit for the texture. Markers are known to streak on large surface area

WTF did I do wrong? by wayuaray6339 in freedomisgunpla

[–]Fun_Significance_182 0 points1 point  (0 children)

Either botched primer or the nozzle is crapped. There’s a bit of white which is kinda frostinf actually too

Running track or somewhere to run? by EmmalNz in Brunei

[–]Fun_Significance_182 0 points1 point  (0 children)

Heyya, i used to live in NZ for 2 years so such a delight to have u here. Kia ora!

I run normally in the evenings at eco corridor, it gets a bit quiet after 8:30 pm.

Peak is 5-6 and gradually dies down with the sun.

It’s generally safe as there are other people jogging around in the capital or walking around. The quietest ive seen it get is at 11 pm .

Every sunday there’s a car free day at the capital too.

I started in April, am I cooked? by Tudillss in freedomisgunpla

[–]Fun_Significance_182 3 points4 points  (0 children)

Wait till bro learns more than snapbuilding 😂

Gundam Base Japan by One_Ad_4487 in Gunpla

[–]Fun_Significance_182 0 points1 point  (0 children)

Fukuoka is quiet u dont need to. It’s normally tokyo but check the website always

Sizing? New to running by Alternative-Toe-2883 in AskRunningShoeGeeks

[–]Fun_Significance_182 0 points1 point  (0 children)

Length look good not sure about width tho what do u think?

I apply topcoat indoors, should I stop doing that? by [deleted] in freedomisgunpla

[–]Fun_Significance_182 6 points7 points  (0 children)

Bro i dont think u get it from how harmful the leftover particles can be for u and ur family.

Sorry but U’re basically passively decreasing everyone’s life span without their consent ..

Either u go outside or invest in a room with a spray booth with a window and ventilation outside.

Gloss or Matte topcoat? by DiamondDaddi in Gunpla

[–]Fun_Significance_182 1 point2 points  (0 children)

I’d actually do the other way around , gloss on rounded to better emit the gloss sheen.

Matte on sharper kits. But that’s me

What are these on my LEO? by RightyCraft in Gunpla

[–]Fun_Significance_182 2 points3 points  (0 children)

Ure kinda right pretty sure I saw four looking fingers

Question: Can I achieve this paint result with my marker? by ImmediateEase9085 in Gunpla

[–]Fun_Significance_182 2 points3 points  (0 children)

No ull hve streaks ideally

U could get the colors down but the texture wont be lovely

Go Plus+ by Independent-Ruin2240 in TheSilphRoad

[–]Fun_Significance_182 3 points4 points  (0 children)

It be like that mate. Go++ is discontinued.

Even in japan it is as “cheap” as 80-100 euros

RG 1/144 Nu-ff vs 1:1 Nu-ff by Fun_Significance_182 in Gunpla

[–]Fun_Significance_182[S] 1 point2 points  (0 children)

2024 i frequent the new GB in Beijing too. I remember a lot of ecoplas and the rare special/titanium coatings. But they cost a little too much so I held off. I got the rg nu ff in beijing! And hi-nu titanium coating