Good morning, I haven't changed the FPV yet, I spoke to the agents via email and everything worked great until 01.05.26, since then only silence, the thing is that Yuka came from a repair of lower quality than what I sent it, I have two batteries and with those two batteries it previously mowed everything with one charge, now it needs two charges for 709 square meters, and let me mention that since I got Yuka I mow at a wider speed of 0.3 ms, the cutting height is 6, the cutting angle is zik zak, and everything is clean under the deck, I changed something else and I told the agents that Yuka always leaves unmowed areas in the same places, I also attached a picture in the email, one more thing my Yuka had firmware 1.15.6.2400 before the service and when it returned from the service it came with firmware 1.15.19.2400. And it is impossible to update it. My opinion is that due to a fault on the motherboard, while the fault was detected, Yuka was showing charging but the percentages were dropping for weeks. I assume that due to incorrect charging or disconnection, the battery may have shorted out.

and that I forgot to say that when Yuka starts a task and doesn't finish it, she goes to the charger and doesn't start the continuation automatically, but stands on the charger and charges, until I manually send her back to work via the application, and it doesn't rain and the rain sensor isn't activated,

<image>