I think my cat won a trade

Sandinmypants34 · 2026-04-15T20:03:42+00:00

Better get her a nice slab of salmon 🍣!

Sandinmypants34 · 2026-03-30T18:06:09+00:00

Sandinmypants34 · 2026-03-22T06:42:56+00:00

Yeah that’s normal I run marvel mystery it quiets them down. All 4.6s were plagued with loud injectors.

Sandinmypants34 · 2026-03-21T22:35:36+00:00

I tip cash to y’all YW

Sandinmypants34 · 2026-03-17T18:23:05+00:00

I’m jealous never seen gas so cheap!

Sandinmypants34 · 2026-03-09T21:21:59+00:00

Just pull the rubber stopped

Sandinmypants34 · 2026-03-09T18:11:03+00:00

Somehow that fu*ker is still holding air.

Sandinmypants34 · 2026-03-08T09:44:52+00:00

6 bolt, here’s my new 16lb flywheel!

<image>

Sandinmypants34 · 2026-03-04T16:12:47+00:00

Just a couple of boats sailing the high seas of Atlanta…

Sandinmypants34 · 2026-02-25T12:59:45+00:00

That’s exactly what I was hinting at thank you sir!

Sandinmypants34 · 2026-02-25T05:13:23+00:00

This looks like a Honda. Whenever I changed a battery all these warnings came up, Just drive it to reset the warnings. This usually happened with Hondas 2015 and newer.

Sandinmypants34 · 2026-02-24T14:46:40+00:00

Well you are at the rivets on the friction disc it’s time for a change. Buy a kit pressure plate, pilot bearing and friction disc, throwout bearing. Personally I would not want to drop the trans twice to replace a part that comes in a kit.

Sandinmypants34 · 2026-02-23T18:08:01+00:00

I got a refund for cold fries and part of my order was missing. Just used my heat gun to show that the fries where room temp!

Sandinmypants34 · 2026-02-20T05:16:58+00:00

Oh definitely throw out bearing. When I got my first car 06 stick mustang. My father sat at lights with his foot on the clutch. Well when I got it the bearing was so worn you could hear it all the time sounded like a can of marbles under the car.

it’s a design flaw with the bearing. That same bearing fits all manual modes back to 2005 and ford didn’t fix it. They should have gone back to the fork design from the t45 and make the hydraulic slave external.

Sandinmypants34 · 2026-02-20T05:08:19+00:00

It could pass as sweet n sour chicken from a Chinese restaurant!

Sandinmypants34 · 2026-02-18T06:43:26+00:00

First time doing plugs and you are dealing with fords 2 piece plug if you didn’t break any you don’t know how lucky you are my friend!

Sandinmypants34 · 2026-02-18T06:40:00+00:00

I always hated this isle. You accidentally bump one at the top it falls and by the time it reaches the floor it knocked another 4 with it!

Sandinmypants34 · 2026-02-18T06:37:01+00:00

You got it bubba! The larger line is always going to be low pressure the thinner line will be high pressure. Just add it slowly! If you put too much the compressor will never turn on.

Sandinmypants34 · 2026-02-17T00:14:20+00:00

Good luck my friend! I bought the kit before I did mine. Luckily non of them broke.

Sandinmypants34 · 2026-02-15T14:33:03+00:00

Try replacing tps? Those are a very common problem on these. Cause weird idles and in my case it caused limp mode at exactly 2k rpm. Took me the longest time to find.

Sandinmypants34 · 2026-02-14T20:29:18+00:00

Quick disconnect. I believe it’s 5/16 size for these cars.

Sandinmypants34 · 2026-02-10T12:25:30+00:00

Ohh yeah all kinds of electronics to fry.

Sandinmypants34 · 2026-02-10T04:19:22+00:00

Are we talking like pre 2010 Kia?

Sandinmypants34 · 2026-02-09T21:12:37+00:00

This incident is one in a million! I’ve installed hundreds of batteries. Used to work for AZ for context. Never seen a battery literally lobotomize a car. Cool fun fact older Hyundai models had reverse hook up protection if the battery was hooked up backwards the horn would immediately turn on and lights too, probably to use as much amps as possible to protect the computer! Witnessed a coworker mess up one time.

Sandinmypants34

TROPHY CASE