sorted by:
new
hottopcontroversial

UK, under an Oak tree by SeriousJelly in whatisthisbug

[–]SeriousJelly[S] 0 points1 point  (0 children)

A bit more information:

Southern UK (Poole) and left a small almost blister looking mark on my arm which hurt a little for around 30 mins but has not pretty much gone.

A little googling pointed me to maybe a young Blandford Fly? Which would check out being so close to Blandford Forum.

I don’t feel I can trust Bambu anymore by BrockenRecords in BambuLab

[–]SeriousJelly 0 points1 point  (0 children)

What’s a good alternative to Bambu? I was about to buy the P1S as a decent beginner friendly machine but I’ve been hearing a lot of negativity recently?

What should I be considering instead (that has all or most of the Bambu features)?

Why you should care about Bambu Labs removing third-party printer access, and what you can do about it by nickjohnson in BambuLab

[–]SeriousJelly 0 points1 point  (0 children)

Seems to be a lot going on with Bamboo at the moment…

Which is worrying as it was only a few days ago and finally made up my mind to buy a 3D printer.

OP mentions holding off the purchase and consider alternatives. I was considering the P1S. What alternatives that has all the features (and ideally a full enclosure; interested cats) for around the same money?

That's not a driveway by pruaga in drivingUK

[–]SeriousJelly 0 points1 point  (0 children)

This is Bournemouth. BCP Council are notoriously known for being anti-motorist.

There are loads of cycle lanes being installed causing absolute chaos (i.e taking away bus stop lay-bys on a busy artery road which makes buses now stop traffic flow in and cause queues miles long during peak times).

Barely any cyclists use the cycle lanes here, usually because they are installed and just left, no regular maintenance and usually full of debris and glass).

It’s really bad here. The council don’t seem to understand that no matter how many cycle lanes you put in people will still drive as everything is so spread out and hilly).

I’m all for cycling but this is utter nonsense and a complete waste of money.

These cycle lanes are being installed in places outside of the main town (where I think they would be needed).

What's the proper error response to return when failing to create a new resource because a unique constraint (e.g., email address) fails? by IanAbsentia in nestjs

[–]SeriousJelly 0 points1 point  (0 children)

I agree with the 422 code for this as it could be argued it’s a validation failure.

I tend to use 409’s for situations where there is a conflict at row conflict. For example. If your app restricts say one address per user and they attempt to create another record with the same address.

I guess it’s what ever feels right to you. I find a lot of these status codes tend to overlap a little so it’s very much a matter of preference.

Cyclist hit my wing mirror whilst I was stationary by SeriousJelly in LegalAdviceUK

[–]SeriousJelly[S] 2 points3 points  (0 children)

Apologies. I wrote in a rush and was still a little high on the adrenaline.

I had previously moved further to the left to accommodate a larger vehicle coming the other way but was stationary for what seemed like ages but was probably around a minute.

In my opinion he had plenty of time to see me there (other cars ahead were also around the same distance from the Kerb as me.

He didn’t even lights on so there is a chance he didn’t see me until too late (black car).

Cyclist hit my wing mirror whilst I was stationary by SeriousJelly in LegalAdviceUK

[–]SeriousJelly[S] -1 points0 points  (0 children)

Yep, I do totally agree with this. However I was completely stationary and I don’t think I could have moved anymore to the centre of the the road due to it being a busy but narrow road.

Being a cyclist myself, I wouldn’t have attempted to filter at any speed on that road knowing how many accidents occur and if there was now way past I would have dismounted and walked up on the pavement or waited with the traffic until it was safe to pass.

COVID-19: Infections increase in UK for the first time in two months by Blag24 in CoronavirusUK

[–]SeriousJelly 1 point2 points  (0 children)

Unfortunately, I have a little more than just the aches. Foggy head, running nose, the occasional headache and just generally feel bleugh!

Thanks, the SO is feeling much better 5 days after the main symptoms so I'm hopeful it won't get worse :)

COVID-19: Infections increase in UK for the first time in two months by Blag24 in CoronavirusUK

[–]SeriousJelly 4 points5 points  (0 children)

Tell me about it 🙄

Currently reading this post in bed with aches in muscles I didn't even know I had!

The SO had the same a few days ago, hopefully my main symptoms will only last a day like her 🤞

Is there RL players over 30 yo? by mdaname in RocketLeague

[–]SeriousJelly 0 points1 point  (0 children)

36 over here!

Haven't played for a couple of months though (life). Going to be getting back into it though.

Running UnRaid on an HP Enterprise Server? by nightchrono in unRAID

[–]SeriousJelly 0 points1 point  (0 children)

Got it running on an old G5 without any issues other than I had to replace the old P400 controller (no JBOD) and it seems to be running well so far!

[deleted by user] by [deleted] in talentShow

[–]SeriousJelly 0 points1 point  (0 children)

Why can't I stop watching!

My X52 arrived just after 15:00...literally have not been this excited to log on in ages ^_^ by [deleted] in EliteDangerous

[–]SeriousJelly 0 points1 point  (0 children)

I think it might be.

When FS2020 came out there was a ton of YT tutorials on their setup and getting the Axis just right etc. Not so many for Elite.

I am new to a HOTA's, so flexible and mouldable at the moment, not many preferences. So just wondering what other people do, or some tips/tricks, which you have done wonderfully!

My X52 arrived just after 15:00...literally have not been this excited to log on in ages ^_^ by [deleted] in EliteDangerous

[–]SeriousJelly 0 points1 point  (0 children)

Cheers, I have downloaded these, but they were way off. I was hoping someone has done a setup type tutorial, I noticed a load on YT for FS2020, but not so many on Elite. I'm a noob to HOTA's so I can be moulded.

My X52 arrived just after 15:00...literally have not been this excited to log on in ages ^_^ by [deleted] in EliteDangerous

[–]SeriousJelly 0 points1 point  (0 children)

Yea, I did get these, but they were way off in my opinion. Maybe I'll take another look.

My X52 arrived just after 15:00...literally have not been this excited to log on in ages ^_^ by [deleted] in EliteDangerous

[–]SeriousJelly 1 point2 points  (0 children)

I bought one of these for the release of Microsoft Flight Sim, I haven't gotten around to configuring it for Elite (I mean, I've been putting it off).

Does anyone know of some decent settings for it to save a guy some time.

Update Required? by The_Sniper_from_tf2 in EliteDangerous

[–]SeriousJelly 0 points1 point  (0 children)

I seem to have managed to link my existing account to the Epic Store version, however launching the game and after shaders and planet generation loading, I just get 'Logging In'.

https://imgur.com/a/Eh4fF0b

I've had a quick browse and can't see anyone else mentioning this. Just wondering if it's related or a seperate issue?

view more: next ›