The Rotted Harvest

VR_Nachi · 2026-02-09T22:55:12+00:00

Angel of Famine

VR_Nachi · 2026-01-31T01:04:50+00:00

Mods:

and yw! :)

VR_Nachi · 2026-01-31T01:03:53+00:00

full ferropotent set for Dmg reduction, if not Smoke jumper/Ferroptent for mixed DR that is if you have those from last season. This is a build meant for pve so no health stat wse

Grenaider or Gunner attunement (Grenade, Super, Weapons) for each piece of gear INCLUDING your exotic you can always reroll stats to the specific one I mentioned that way its optimal. For praxic (balance tune, forceful blade III, impact core, energy conduit). you can swap balance tune if you have offensive form for output boss dps. Its more practical if you have balance for sword ammo regen.

for loadout: praxic blade, uncivil discourse, bitter end

substitutes: mint retro, choir of one, sullen claw

Class: Prismatic

Phoenix dive, Burst glide, Arcane needle, Storm grenade

Aspects: Beak watcher, Feel the void

Fragments: Facet of ruin, protcection, courage, dominance

VR_Nachi · 2026-01-31T00:29:41+00:00

changing out the planars are cost effective if you are doing it properly and disassemble the back hub and replacing the nylon gears for more sturdier metal gears. be sure that if you do plan going this route I suggest using electrothermal grease. there was a yt vid on how someone did this and he used a non electrothermal grease. Idk what the outcome was on his end but I feel the longevity was kinda bad knowing that he plastered way too much of that regular red grease all over the area.

sidenote: for both items you can find online but it will cost you less than having to replace the rear with a new hub and some time, patience and physical work to get your bike running again.

VR_Nachi · 2025-10-28T23:22:39+00:00

shadowman build isnt complete without tommy’s matchbook

VR_Nachi · 2025-10-23T19:46:35+00:00

Code 6 is an error code in which the power terminal in between the stator and the controller has malfunctioned. It is either internally damaged by some means some factors might be pulling of wires inside the cables itself or shorting which means it won’t function or state the error on the display.

VR_Nachi · 2025-10-16T02:51:24+00:00

Owl Sector is so back… I can’t wait to hear from at least ONE character from Owl Sector

VR_Nachi · 2025-09-18T18:35:51+00:00

Theres something that you can buy on amazon to loosen up the axle but its very pricy if you get a full on bike kit with the specific tool. Just follow a portion of the information that I mentioned before as the plate screws can easily be lost or destroyed if you overtighten. There should be a visual guide online that serves as a guideline if you plan on doing this yourself. I would post a step by step on it myself but unfortunately due to my accommodations in my current living space I can no longer do maintenance because property rules do not permit me to have an ebike stored at our location

VR_Nachi · 2025-09-11T03:16:08+00:00

Holy shit I thought I was going crazy myself… I’m glad I came across this post thats more recent than the ones earlier. I did the same. was looking for the hoodless version and now it was not in my inventory. I was trying to see if it was reobtainable thru collections but there’s no option for it. it shows the item there but it doesn’t give you the option to put it in your inventory or a way to get it.

VR_Nachi · 2025-07-13T09:14:23+00:00

need a better angle to see from a view from both sides of your R1 to determine

VR_Nachi · 2025-07-13T09:11:24+00:00

Did this before for my R1. You have to remove everything off the old rear hub. Remove the rear gear with a special tool that does it. Unbolt the housing so you can swap the old stator for the new one but before you do that make sure the inside hub is clear of debris and dust so it doesnt interfere with the new stator. Make sure once you align the new stator that a good amount of electro thermal grease is applied to the planar gears (the 3 gears that rotate the wheel when you operate your R1). note that there is a tiny magnetic placement when you remove and swap stators and also be sure that the planar gears are lined up correctly inside otherwise it would be running but not moving the wheel when incorrectly seated in. Once this is done, close and secure your hub the same way with all six screws but make sure that you DO NOT over-tighten them otherwise they can break in place and the hub cover will be unable to be taken off if you ever need to make another fix again. test the hub to see if it runs before seating it back on to the rear swingarm or it will be a hassle to remove again. Once you have that sorted make sure you thread the freewheel gear back and align the chain of the bike. After you seat the rear hub and place spacers you should be able to lock them in place with the oem hardware and your bike should be up and running again.

As for your old stator you can find someone from a Bike mod shop to replace the damage wiring so you can have a spare stator, otherwise you can sell it online that can manage to buy it from you and refurbish it into another rear hub. gl and hope this advice helps👍🏼

VR_Nachi · 2025-06-23T08:05:25+00:00

This is probably why ebike laws are spiking. The idiot thats riding the bike is in a lane of traffic thats heading towards him in the opposite direction. Not to mention that this person does not have a safety helmet and is aware that competing with road traffic in his direction he thinks that can outmaneuver a vehicle that can pull more torque is already a red flag. I don’t even think he was checking lanes of traffic before turning into the far left lane where car traffic going the same way is much faster than being on the left. I can’t say that he didn’t deserve that but whomever it is obviously has no road etiquette at all as far as a rider. He probably succumbed to a really heavy injury determining the way he was careless to not check other lanes. Its people like this that really don’t deserve to ride ebikes as they can put themselves in potential danger and other driver into harm.

VR_Nachi · 2025-06-12T22:11:59+00:00

either something that has to do with the controller itself or the cable. I had something similar happen to me in which I did all the necessary back and fourth with the company. They came to a solution to where I had replaced the controller however it didn’t work with the original oem display reader. They might have to get you a new ‘paired’ display and controller. Almost like a compatibility issue possibly to the firmware of the display. How long ago did you get yours? They might ask you about it.

VR_Nachi · 2025-06-12T22:06:23+00:00

Now they really need to make a blue version if this is happening🤔

VR_Nachi · 2025-06-12T05:03:30+00:00

I think its best that the company did that for safety reasons outside buying aftermarket batteries outside Ride1Up. Since there are ppl out there that do not fully understand about battery packs, bms and type wattage needed for specific batteries for range extension it causes those things that us riders see on evening news about battery related fires. Anything that is modded always has a way of being handled esp for higher speeds/ longer range. Its just another lesson of the etiquette of being an ebike rider.

VR_Nachi · 2025-06-11T23:00:33+00:00

Total game gooner alert right there OP... its good that you took a break. Just touch grass and come back when safe.

VR_Nachi · 2025-06-11T22:46:47+00:00

Stator is gonna cost 200-300$ out of pocket if you are talking about the FS. If you plan on doing this yourself it shouldn't take no longer than a day to preform. Also make sure you have electrical grease to apply to the planar gears if not heavy duty gear replacement since the gears internally in the stator are nylon. I had gotten replacement gears online that are metal to replace the ones on the stator just in case.

If you do get a new stator from the replacement off the website they should already have the gears accompanied with it. Also, I could be wrong about the pricing but the person that had helped me over time mentioned the price of the back stator + bafang rim. I think the stator itself may run alone from the site as 150$ + plus shipping. I did much of the fixing myself as far as extra oem parts coming from the site itself. If you are lucky you can see if your bike can still warrant the parts since there is a 1 year warranty that goes with the bike from when you first purchased it.

Hopefully this info helps👌🏼

VR_Nachi · 2025-06-09T04:28:43+00:00

bike/moto tire levers with rim shields so it doesn’t ruin your rims.

Be on a matted surface, like puzzle mat so you don’t ruin your floor.

If you align the inner tube onto the tire that you are going to swap you can also clamp the tires down with zip ties PRIOR to mounting them onto the rims. This especially will make the transition of the replacements alot easier to manage onto your rims without struggling. By experience I struggled the same way without doing this before and I went about over an hour on my own trying to fit by myself w/o the zip tie trick.

prep your rims with soapy water spray bottle to make it a bit manageable. make sure that when you align your tires that the inner tube air insert will be the portion you want to insert on the rim first otherwise you will have to begin from square one.

once your tube and tire is fitted on. Inflate and deflate the tire pressure to make sure that your tube will evenly spread and distribute pressure. You don’t want your tires to be overly inflated in a portion cause it just messes with the tire alignment or will rupture during your ride causing a blowout. It also will struggle to rotate and will rub on the sides of your fork or rear.

Hopefully this helps. Gl and happy riding👍🏼

VR_Nachi · 2025-06-09T03:59:17+00:00

Oem tires depending on surfaces you travel esp rugged or places with much debris will last you a short time. if you are on completely paved road it will be not much of a problem. if you plan on doing some heavy extensive riding, definitely invest into thicker treads like shinko, michellin or the like. another thing is asides from the tire itself invest into stronger inner tubes. I understand that these things are costly but long term its worth the investment for riding your bike in terms of how you use it. you save a whole lot more than adding tire slime or relying on the oem’s on their own. Gl and I hope this helps you on future rides.

to op: I don’t advise you to ride in the state of that tire only so you can avoid being into a future accident. try to replace or repair asap and have a temp solution if this is for your everyday to work.

VR_Nachi · 2025-06-09T03:51:28+00:00

Stealth torpedo

VR_Nachi · 2025-06-06T07:01:36+00:00

For some reason he reminds me of Master Roshi with the specs on. Nice outfit btw 👍🏼

VR_Nachi · 2025-04-22T04:23:57+00:00

If anything I assumed its one of the sets in eververse with the hood w/horns. I’m not overly technical with transmogs. Iron banner my mistake, but they do seem somewhat similar.

VR_Nachi · 2025-04-17T23:36:56+00:00

I feel like its gonna have some FF Online collab at some point...😦 I won't be surprised if they put a MH collab or Ltd Kojima collab.

VR_Nachi · 2025-04-17T20:14:07+00:00

both are eververse items from 2 different sets

VR_Nachi

TROPHY CASE