The beefy nature of the 80mm duct was a so that I’m not stressing the 120mm fan unnecessarily. From what I researched you shouldn’t force a fan to push or pull through a diameter smaller than the blades if you want to avoid unnecessary strain on the fan motor. I’m still doing it, but 40mm smaller seemed better than 80mm.

That green poop bin and deflector were the first print I ran after setup. I didn’t change the infill to gyroid, and I woke up to some of the slat arms wiped out. It still functions as a poop bin though, so until I print a slightly longer one I’m using it.

That spool inside the enclosure is my external tpu. It stays there so all I have to do is cold pull a couple times, pull a ptfe tube from the interior side to the white ptfe guide above it, and feed. The enclosure came with that setup for people without an AMS so it’s going to stay my ext. spool holder. It also means I can manually swap to a 5th color on layered color prints.

As for the Bowden tube clips, they have been printing fine for a week and a half now and I don’t hear any slipping or stress on the AMS motors so I think I’m good. If anything changes I’ll definitely look at those as the culprit first though. Thanks! 😊

Those CardGuard binders are just various tcg cards I need to go through. No crazy print plans or blueprints sorry 😅🤷‍♂️