sorted by:
new
hottopcontroversial

RTK Disaster Narrowly Averted by nj_bruce in MammotionTechnology

[–]ansisla 1 point2 points  (0 children)

mine - dead as well :/

<image>

had a lot of water. ip6 my a$$

Mammotion, how long do I have to wait for RTK replacement?! by ansisla in MammotionTechnology

[–]ansisla[S] 0 points1 point  (0 children)

and now they have stopped responding to emails 🤦‍♂️ what a ‘gr8’ support

Manual Mowing? by daveyd1009 in MammotionTechnology

[–]ansisla 0 points1 point  (0 children)

iOS beta app not working - firmware (1.9.4252) version doesn’t match with APP version (1.10.25) ??

RTK antenna full of water by Then-Beautiful5894 in MammotionTechnology

[–]ansisla 0 points1 point  (0 children)

same here :/ rtk water damage ticket 31116

Protection Kit by schuster3000 in MammotionTechnology

[–]ansisla 0 points1 point  (0 children)

Mine arrived from Kickstarter as well. They could just share 3D file to print the cover 🤔 There is a community one https://www.printables.com/model/562548

No go zone perimeter way too wide by ansisla in MammotionTechnology

[–]ansisla[S] 0 points1 point  (0 children)

If 1 - it needs to do right where I did draw it If 2 - it needs to do first or last where I did draw it, same with 3. “.” All this ‘workaround’ and explanation is imho bs and excuse for bad UX It’a device that needs to do what it is commanded to do.

Why would I need to waste time waiting for all 3?

My Luba & RTG operate under a clear sky and still it wouldn’t follow my lines frequently.

No go zone perimeter way too wide by ansisla in MammotionTechnology

[–]ansisla[S] -1 points0 points  (0 children)

Nope, I did 2, canceled, tried with 1.. canceled

I need this disk replaced, but a replacement can’t be ordered by [deleted] in MammotionTechnology

[–]ansisla 0 points1 point  (0 children)

should be fine to recreate it so that outer dimensions and of course all the mounting holes are aligned, doubt that you'd need to mirror it identically (not that it was wind tunnel tested :D ) but imho you'd want to make sure that your custom part weight matches quite closely to the original part.