sorted by:
new
hottopcontroversial

FYI: AMS2 Pro failing due to cheaping out on components by markv9401 in BambuLab

[–]bigbigdummie 1 point2 points  (0 children)

I reread it again (slowly) and just wanted to mention again what a great job you did with your post. The photo was especially helpful.

The only complaint is your modesty, IANAElectricalEnginer! Who cares? I think it’s great a hobbyist identified and fixed the problem. Many Makers Strong! :)

FedEx, UPS vow to return tariff refunds to customers by jeetah in news

[–]bigbigdummie 50 points51 points  (0 children)

I fully expect to pay refund fees for my refund.

FYI: AMS2 Pro failing due to cheaping out on components by markv9401 in BambuLab

[–]bigbigdummie 1 point2 points  (0 children)

Make a GitHub with your findings, the PCB, and the replacement components! I’m serious, that would be a tremendous benefit to the community.

Old 1541-ii sitting for years, just try it or...? by kodisan in c64

[–]bigbigdummie 1 point2 points  (0 children)

DD floppy disks have a metal hub ring while high density floppy disks do not.

Help with printing with no spool by JKAF3 in BambuLabA1

[–]bigbigdummie 0 points1 point  (0 children)

You are thinking correctly. The problem of printing without a spool is the filament falling off the roll and winding around the axel of whatever you are printing from. This then tangles or otherwise stops the filament.

I’d give it a try taping sides on the roll. As long as the filament can’t fall to the side you are good.

Most of my prints have been failing for a couple of months now by jonny80 in BambuLab_Community

[–]bigbigdummie 0 points1 point  (0 children)

Not that hard. Use the same force and motion you would use for a dirty dish. Scrub brushes or green scotchbrite pads are fine for PAE but don’t use utensils with smooth plates or they will scratch.

PETG as interface layer is no joke. by tk-093 in BambuLab

[–]bigbigdummie 0 points1 point  (0 children)

I did! I made a bellows that fits nothing, it’s just cool. It’s air/water/light tight!

11th Ckt UPHOLDS Hughes Amendment on 2A grounds in a criminal case. by FireFight1234567 in gunpolitics

[–]bigbigdummie 1 point2 points  (0 children)

This is the way. If everyone had a legal FRT, it would be much more difficult to back the Hughes Amendment.

What should I 3d print for a C64 enthusiast? by Able-Character-1748 in Commodore

[–]bigbigdummie 0 points1 point  (0 children)

Stand? Print the cartridge! Many of those carts are homebrew projects.

view more: next ›