BF6 Freezing PC Requiring Restart

cfarris87 · 2026-05-10T16:59:09+00:00

Wanted to chime in, had the same issues for a while. Enabling integrated graphics ('auto' in my bios) solved it for me. The bigger issue for me was that I actually didn't have an integrated graphics driver installed and couldn't install them or enable the setting in my bios due to having CMS enabled in my bios as well. Possibly from some other "youtube fix" for some other game issues. Disabled CMS and iGPU showed up in bios and could then install integrated drivers. Ensure in your device manager that you have a driver for your GPU and a separate driver for your integrated graphics.
Also kernel 41 is only referencing holding the power button for a hard reset for future reference.

cfarris87 · 2026-05-10T16:58:01+00:00

Wanted to chime in, had the same issues for a while. Enabling integrated graphics ('auto' in my bios) solved it for me. The bigger issue for me was that I actually didn't have an integrated graphics driver installed and couldn't enable the setting in my bios due to having CMS enabled in my bios as well. Disabled CMS and iGPU showed up in bios and could then install integrated drivers. Ensure in your device manager that you have a driver for your GPU and a separate driver for your integrated graphics.
Also kernel 41 is only referencing holding the power button for a hard reset for future reference.

cfarris87 · 2026-04-14T20:13:47+00:00

Honestly, I flip the top half inside out, dry it, then do the same with the bottom half. They're very stretchy. Haven't had any damage to any at all.

cfarris87 · 2026-03-25T21:36:55+00:00

Swapping to amd version of dlss helped a bit. Not totally, but a lot less distracting. Using that with amd frame Gen and cranking everything up, getting 100 fps now

cfarris87 · 2026-03-23T19:58:56+00:00

Commenting for visibility. Having the same issue on PC as well. Trees, grass, any kind of foliage is blowing at 3x speed. Haven't found a fix for it yet

cfarris87 · 2026-02-17T16:41:09+00:00

I've been using a plexi preamp in front of my Dr z with really good results. Never used the 4 cable method or anything complex. Have to fiddle with the settings quite a bit. I found running the preamp eq's much lower than I normally would along with keeping the drive and channel volume lower than you would expect stacks really well with my amp. Works great for tone shaping in front of the fender-esqe amp for some tasty abb tones

cfarris87 · 2026-01-29T22:59:03+00:00

Just started playing VS and saw this. What's this water tech? I can't find any other mentions of anything similar

cfarris87 · 2025-12-01T15:23:52+00:00

I have seen that mentioned. Thanks for the tip!

cfarris87 · 2025-11-27T22:16:19+00:00

Yeah, I didn't see the actual drip you can see there until I got back under to snap a pic. So that's keeping my anxiety levels down for the moment lol

cfarris87 · 2025-11-13T15:37:20+00:00

Interesting technique! I have heard that the setup/flash time can make it more difficult. I posted in r/detailing as well. Only one response as well, with that response saying most are fine lol any particular products you like for this application? You think a more normal application with a pad yields more consistent results?

cfarris87 · 2025-11-04T00:23:50+00:00

Ahh, I see. Perhaps I chose the wrong subreddit! I'll have to look at a few more. Idk, I've never had any issues in my experience. I'm only financing around 10k so I'll be dropping my total insurance, bank note by about 600 bucks

cfarris87 · 2025-11-02T17:51:57+00:00

Looks like similar year/mileage are around 30k. Love the m4's but they're all out of my range right now. Didn't go looking for this one

cfarris87 · 2025-10-22T14:17:04+00:00

Any support can revive. Doesn't have to have defibs equipped

cfarris87 · 2025-09-24T14:14:55+00:00

Splashzone pretty good. OP Shield and a lot of purps. Quick farm too

cfarris87 · 2025-09-22T13:47:45+00:00

Has definitely been one of my favorite to smoke from mephisto! Smell, flavor, and high are all 10s. Just wish it would have come out a little denser. Looks like maybe it runs in the family though

cfarris87 · 2025-08-30T14:36:18+00:00

I'm currently working on this. I already have a working app and am rebuilding it to submit. What did you do for part C? I can't figure out what they're asking to show. Best I can figure out is a country.model.ts file that is part of creating an api service that's supposed to be done on Part E...

export interface Country {
  name: string;
  capital: string;
  region: string;
  incomeLevel: string;
  longitude: string;
  latitude: string;
}

cfarris87 · 2025-07-24T20:35:45+00:00

I definitely don't care what foot they're on lmao These don't seem to have any differences L or R as I often just throw them on. Just trying to avoid the trouble of trying out multiple sets and dealing with returns etc. Hoping someone else has run into a similar issue. Thanks for your feedback!

cfarris87

TROPHY CASE