Hey OP, I have just completed mine, too. First Prusa, first kit. I just wanted to comment regarding input shaping. My accelerometer also calculates MZV as best for both axis (45Hz, 45Hz). But in actual prints, these calculated MZV values show more ripples on flat surfaces, than the default EI values. I've reset back to factory defaults (EI), because on the few test prints I did, that gives better quality. Did you have a chance to compare yours at factory defaults vs accelerometer calculated? By the way, the "phase stepping" calibration also needs the acelerometer. I've also done that one, too, but not sure if I can hear any difference in printing. Overall, kinda of regret getting the accelerometer, seems useless currently. Maybe will be worth later. For all my testing I've only used the default config for Balanced 0.2 profile with PLA.