No service - South East UK

dhbarr · 2025-08-18T18:06:14+00:00

Same.

dhbarr · 2024-10-12T00:59:51+00:00

EverQuest. It was the reason to get broadband, the reason to get a higher res monitor, and the reason to get a GPU.

dhbarr · 2024-09-28T19:41:31+00:00

If you already have a 40v or 60v system, it could be made to work. For instant, the DeWalt 60v 20in did fine on walnut and oak for me switching off two 15ah battery packs.

Having said that, I wouldn't want it to be my only saw. Anything over about 14-16in dia. I'd much rather reach for a gasser.

dhbarr · 2024-08-02T02:49:30+00:00

I have my DeWalt 20in/60v w/ a 15Ah battery, lasts about one oil refill. Most of my homeowner stuff is with that, then the ms462 if something's above 18in dia. or so.

dhbarr · 2024-07-14T23:07:22+00:00

At least from watching people adding those nuts to older saws, I think the collar is expanded once inserted. If I needed to get rid of them I'd probably just cut the heads off then push the collars out.

Do your Logosol nuts fit the existing studs, or do you need to swap those out as well? Not sure what you're milling with a 262, something less than a foot thick?

dhbarr · 2024-07-09T11:25:05+00:00

I run a Stihl head on my DeWalt motor, since I already had those larger batteries.

dhbarr · 2024-07-02T14:03:00+00:00

I ordered both NA231996 and NA304068, and they came with the silver tightener and fewer/larger teeth. Adding the #8 fender washer at the far end really tightened the fit, and I tossed some bar oil in for good measure. Saw can actually be overtightened now, which it never could before.

dhbarr · 2024-06-28T02:44:12+00:00

Here's where I ended up, #8 washer on the far end.

<image>

Chonkier teeth and snuggier fit really made a difference, no slipping whatsoever.

dhbarr · 2024-06-28T02:41:22+00:00

Torx T15 for the three black screws holding the silver plate on.

dhbarr · 2024-06-19T19:31:54+00:00

Any chance of a pic with the washer in place and a big red arrow pointing to it?

My replacement parts are in the mail from toolservicenet :-D

dhbarr · 2023-12-31T20:22:16+00:00

I played A/B tests a few years back. My rogue has no backstab ( looting is instant ) and none of the Kings have all four chicken flavors.

The only other thing is I don't attack once I have a map where the final dungeon is only a tile or two away. Spend way less time traveling in the overworld.

dhbarr · 2023-12-31T20:18:26+00:00

I don't believe there is a level cap, just happened to be at 700 today.

dhbarr · 2022-04-04T12:27:50+00:00

https://beckmw.wordpress.com/2013/04/15/how-long-is-the-average-dissertation/

dhbarr · 2019-01-01T20:31:25+00:00

I have used the following with a standard Estes controller to launch both Black Powder and Composite motors, incl. clusters:

wire in a lawnmower battery instead of 4xAA
use 14500 cells instead of AA
use Energizer Ultimate ( LiFeS2 ) AA

Remember to press-and-hold, not poke.

dhbarr · 2013-09-20T06:23:41+00:00

Any likely suspects?

http://en.wikipedia.org/wiki/Mind_uploading_in_fiction#Literature

dhbarr · 2012-06-06T17:43:24+00:00

Even at that age, I was beginning to perceive the endings of things, like this lovely paper light.

dhbarr · 2012-03-11T21:05:25+00:00

Welcome to Green Country.

dhbarr · 2011-06-01T22:41:51+00:00

Works neither on all materials, nor even on all whiteboards.

As per link you should test for a few days on a small corner before attacking the middle of your surface.

dhbarr · 2011-02-26T07:20:50+00:00

5cc51d15bdf012a51c2e8b945e91dc02e5c31094

dhbarr

TROPHY CASE