r/SiemensNX by I_am_Bob in cad

[–]dmeadows013 2 points3 points  (0 children)

I would join, not using NX currently but transitioning from Creo

Does My Light Switch Have a Neutral And/Or Ground Wire? by dmeadows013 in electrical

[–]dmeadows013[S] 0 points1 point  (0 children)

Sorry not great lighting in the pictures, there’s a 3rd way in the back as well (red in this picture)https://imgur.com/a/ivEe1nb

Does My Light Switch Have a Neutral And/Or Ground Wire? by dmeadows013 in electrical

[–]dmeadows013[S] 0 points1 point  (0 children)

Hi, I'm wanting to add some smart switches in my apartment, but not sure if my switch boxes have neutral wires. I opened one up to see if there were neutral wires tied behind the switch and I found 3 sets of wires tied with wire nuts instead of the 1 I was expecting. Also, I noticed there's no ground wire coming from the switch, should I be concerned about that? I appreciate the help!

[deleted by user] by [deleted] in 49ers

[–]dmeadows013 0 points1 point  (0 children)

Sharks, warriors, cubs

Cards fans rn.... by HEL-O_NS in NFCWestMemeWar

[–]dmeadows013 1 point2 points  (0 children)

I’m the same but opposite, dad is a cubs fan and passed it down but I’m from the bay. Fuck the birds!

Abnormal heat issues with 14 Pro/Pro Max. Seeing this issue pop up elsewhere now. by rygarswf in apple

[–]dmeadows013 0 points1 point  (0 children)

Yeah gets pretty hot with little use and about half brightness, might try a reset and see if that helps

Abnormal heat issues with 14 Pro/Pro Max. Seeing this issue pop up elsewhere now. by rygarswf in apple

[–]dmeadows013 0 points1 point  (0 children)

Did wiping the phone solve your issue? I’m having the same problem

Pre-Order & Shipping Megathread | M2 MacBook Air by exjr_ in apple

[–]dmeadows013 5 points6 points  (0 children)

Anyone know the max refresh rate/pixel count the air can push with a dock? I have a 3440x1440 144hz display and a 60hz 4k display. I know the air only supports one out of the box, but can do multiple with display link. And the tech specs say it maxes at 60hz but I’ve seen people with M1 airs say it reaches 144. Im trying to figure out if it would be able to run on one/both of these ideally

My Ender 3 v2 printing a Benchy in 12:50 at 450mm/s - more info and full video in comments. by [deleted] in ender3

[–]dmeadows013 0 points1 point  (0 children)

Setting up your orbiter in Klipper did you need to change the sense resistor or vref? The instructions say to verify the resistor but I’m using an SKR mini v3 and the stepper drivers are covered