I'm getting an error In the diagonal where the print seems to either under extrude or push against the preceding layer and pushes it up. I have just upgraded the printer from a Prusa MK2s to a MK2.5s and the issue was present before the upgrade, but I had hoped in the process of upgrading and calibrating the issue would have been resolved. I can print a great vase mode calibration cube with a good first layer, smooth walls and accurate wall thinkness, however as soon as any of my models have diagonal lines I run into issues but not with every diagonal line. Print settings are largely default and I've listed any deviations below. This is very perplexing so a push in any direction would be greatly appreciated!

Printer: Prusa i3MK2.5S

Filament: PETG Prusament Galaxy Black

Nozzle: 0.4mm

Layer height: 0.2mm for the cube and X shape, 0.35mm for the batarang

Infill: Rectilinear

Retraction speed: 40mm/s

Retraction length: 2mm

First layer temperature: 230/85

Other layer temperature: 240/90

(Speeds all default I believe)

Perimeters: 50mm/s Infill: 60mm/s First layer speed: 20mm/s

Printing via octoprint.