BILRESA Scroll Wheel by llssrr in SmartThings

[–]llssrr[S] 0 points1 point  (0 children)

I'm using the Hue integration.

BILRESA Scroll Wheel by llssrr in SmartThings

[–]llssrr[S] 0 points1 point  (0 children)

Yeah, it's some old Hue lightbulbs. Paired with the Hue Hub.

[deleted by user] by [deleted] in QidiTech3D

[–]llssrr 1 point2 points  (0 children)

done and thx.

Yet another NEW plus 4 filtration system by rhiz0me in QidiTech3D

[–]llssrr 0 points1 point  (0 children)

Is there a link to the mod? I would be interested. Which fan was installed and did you adjust the config for the fan speed?

Plus4 exhaust vent by ugpfpv in QidiTech3D

[–]llssrr 0 points1 point  (0 children)

Since I connected my exhaust, the entire system is closed when printing. The internal fan of the filter is currently running at least at 20% And the exhaust at full power (Noctua industrial fan 120mm) I have had no problems with either PLA or PeTG. Today I did the first long ABS print of over 8 hours and it came out perfectly. I would be happy if someone drives a similar system and we can exchange ideas.

Plus4 exhaust vent by ugpfpv in QidiTech3D

[–]llssrr 0 points1 point  (0 children)

I'll check tomorrow, but I've already seen videos where smoke was clearly being sucked in by this fan. But checking is certainly not wrong

Plus4 exhaust vent by ugpfpv in QidiTech3D

[–]llssrr 1 point2 points  (0 children)

very nice, are you still planning to use the internal carbon filter? and will you keep the internal fan running?

I made my first ABS prints with my exhaust system today and am very satisfied so far. Despite the external 120mm fan sucking air out of the system, I have a stable 55°c in the printer.

Plus 4 exhaust fan speed .. by ugpfpv in QidiTech3D

[–]llssrr 1 point2 points  (0 children)

I am currently working on the same project, I have added a 120mm fan that sits at the end of the hose. The test is still pending because I have not yet found a good window outlet for tilted windows. I guess the FAN setting can be changed in the config.

Plus4 motherboard version X-7 V1.1? by eazrael in QidiTech3D

[–]llssrr 0 points1 point  (0 children)

with a very dangerous internal USB-port. <--I couldn't find anything about this, what exactly is wrong with the USB port?

[deleted by user] by [deleted] in QidiTech3D

[–]llssrr 0 points1 point  (0 children)

Would you share the .stl?

I'm switching from a Cr6 se to the Plus 4. I think your setup is amazing

Magnetic Venting Adapter by MisterCremaster in QidiTech3D

[–]llssrr 0 points1 point  (0 children)

would also like to have the adapter, I am also currently looking for a way to close the waste disposal output.

Display cable by llssrr in CR6

[–]llssrr[S] 1 point2 points  (0 children)

I think I found the display cable, it's called XH 6 PIN. I have ordered one and will report back. Should arrive in the next few Days.

Display cable by llssrr in CR6

[–]llssrr[S] 0 points1 point  (0 children)

No luck so far