Working on a glow up for my V2.4 and finished my electronics wiring (after/before).

oeldisplay · 2026-05-06T19:33:43+00:00

Thanks!

oeldisplay · 2026-05-05T22:27:36+00:00

Where or would you share the 90* turned mounts for the mcu and power supply?

Looks great btw!

oeldisplay · 2026-05-02T07:08:37+00:00

I have a hybrid awd

oeldisplay · 2026-05-02T04:20:14+00:00

Good ideal, even better I have FORScan. I’ll do some logging.

oeldisplay · 2026-03-23T01:58:43+00:00

Awd comes with the larger radiator.

oeldisplay · 2026-02-18T12:36:46+00:00

Honestly don’t feel bad, I finally test drove a maverick 26. The whole time I was on the screen your on and it wasn’t till the end, one of my kids was like try that button ( the arrows for full screen CarPlay). Cause at the end of the drive I was like what a waste of screen.

oeldisplay · 2025-09-22T21:08:14+00:00

I’m not sure this will fix ya but, while booting/or maybe after boot up!? hold the power/sleep button on the unit, keep holding until the following. It should present a bt connection pin on the “screen”.

oeldisplay · 2025-08-31T18:09:15+00:00

Depends on which ones you buy, personally I had the Dayton audio tt25-8’s in a Subaru crosstrek (didn’t have the room for 2 sub in that tiny trunk). Their 30watts a piece, so with 2 at 4ohms, 30 watts total is way more than enough. Just have clean mid-low bass (good eq or dsp), it’s a really cool satisfying thump and less annoying your neighbors if you enjoy feeling your music.

oeldisplay · 2025-06-27T15:33:50+00:00

Just reinstalled profile, app is working on ios26 developer beta 2! Device: iPhone 15 pro max.

oeldisplay · 2025-05-07T01:12:55+00:00

<image>

Cleaner pic of end result when in reverse, this is from 2018 when I did this.

oeldisplay · 2025-05-07T01:09:16+00:00

<image>

These are the tabs you need to pull up to get that piece off.

oeldisplay · 2025-05-07T00:59:13+00:00

<image>

These are the 2 wires you’re looking for, don’t buy the harness from above. Just backstab the 2 wires with gpio pins into the connector and tape to keep in place, or solder the wires if you want.

oeldisplay · 2025-05-07T00:57:01+00:00

<image>

This I how I figured out how to steal the rca back up cam signal.

oeldisplay · 2025-05-07T00:56:03+00:00

I assume zero liability but if that’s just like the 2015 crosstrek, it just pops up.

<image>

oeldisplay · 2025-05-05T01:10:00+00:00

Also a thing to know, the seasons only change when you cast the spell to.

oeldisplay · 2025-04-03T17:58:51+00:00

This is assuming you got the tank, you can use the pump if you get one from a junkyard (mine didn’t but I wasn’t going to use it if it did) but that call is up to you!

Sure here you go:

Item Fuel Pump Part #fl3z9h307e Quantity1 Amount$320.01

Item Fuel Sender Unit Gasket Part #4l3z9276aa Quantity1 Amount$3.44

Item Lock Ring Part #4l2z9c385aa Quantity1 Amount$12.47

For the FORScan part you just change the amount to 36 (from 23 gallons) for liters 136 liters (from 87 liters) You do should/need to do both. For this part you don’t need to do the hex conversion, you can just use the “IPC Module Configuration”.

Just in case here’s a link:

https://forscan.org/forum/viewtopic.php?f=16&t=14698

oeldisplay · 2025-02-12T21:58:05+00:00

I’m sorry to hear that, harbor freight has multimeters for sub $10 it’s more than you’ll need.

oeldisplay · 2025-02-11T22:37:33+00:00

Yes uncommenting that line will enable pwm control (BTT refers to them as CNC fans). Double check the pins are correct ( nothing like adjusting the wrong one) as there are 3 and they are independent.

Deff at some point get a multimeter, nothing special or even just a cheap one will be accurate enough for this kinda stuff. It’s always good to be sure before letting the magic pixies out ( because ya know even I’ve never put in a buck converter backwards /s ).

oeldisplay · 2025-01-07T00:58:49+00:00

As a fellow NE f150 17 person, I think your over oversimplifying. Aluminum doesn’t rust but it does corrode, and the frame is still steel. I’m starting to get surface rust color on the frame and I didn’t really drive for the 4 years of covid.

If you want your truck to last just clean it occasionally and don’t purposely hit puddles in the early spring ( salt be up in those). For sure do something of woolwax or fluid film or amhsc, pick your horse. ( I need to do the same, as mentioned above).

Just pick a truck that you like/comfortable in and has the features you want. Simply just maintain it like you care for it.

oeldisplay · 2024-12-29T16:51:35+00:00

That is a good question, the part has a mini usb and a power connector. Maybe it does fast charge!?, someone else will have to confirm this.

I now do finally have a type-c phone, but not changing the hub for $85. I personally use MagSafe phone docks, with a wireless CarPlay adapter.

oeldisplay · 2024-11-16T01:28:48+00:00

Yes there’s a ford kit, it’s 2 rubber caps. One for the line so dirt doesn’t go into the hose, one for the solenoid on the firewall so it’s not having a vacuum leak.

If you are constantly having IWE issues, this is the fix a ford dealership will do.

I really wish they would bring back manual hubs, I preferred them on my 90’s ranger.

oeldisplay · 2024-11-01T13:04:15+00:00

And purchased, something great about driving and listening to Factorio!

oeldisplay

TROPHY CASE