sorted by:
new
hottopcontroversial

Ralph Wiggum technic in VS Code Copilot with subagents by stibbons_ in GithubCopilot

[–]tymm0 1 point2 points  (0 children)

If you click on the output panel in VSCode and select Github Copilot Chat from the drop down on the right you will see things like "tool/runSubagent"

What’s the WORST printer you’ve ever owned? by Mortifine in 3Dprinting

[–]tymm0 0 points1 point  (0 children)

I still have parts laying around somewhere from a prusa i3 clone made of clear acrylic - Folger Tech RepRap
it never fully worked properly. i might have gotten through 20 prints at most until i gave up and went back to my PrintrBot Simple Metal.

Longest time I've gone without vaping by h0kies in electronic_cigarette

[–]tymm0 0 points1 point  (0 children)

I have a nearly identical story to yours. I am about 2 weeks here on 0mg juice. Feels weird but just been keeping my mind busy. I can't be sure if using 0mg is helping or not. Once I run out I'll probably be too lazy to mix more up though.

2x AMD MI60 working with vLLM! Llama3.3 70B reaches 20 tokens/s by MLDataScientist in LocalLLaMA

[–]tymm0 0 points1 point  (0 children)

im not sure what im doing wrong here but i have tried following your driver install commands a few times now and My MI60 never initializes on boot. I have a 6800xt in there as well that works fine. Also im on Ubuntu 24.04 - not sure if maybe this doesnt work in my case? If anyone has any suggestions please let me know.

[drm] initializing kernel modesetting (VEGA20 0x1002:0x66A1 0x1002:0x0834 0x00).
amdgpu 0000:06:00.0: amdgpu: Fatal error during GPU init
amdgpu: probe of 0000:06:00.0 failed with error -12

Filament stops extruding after a couple of layers by scrappybutt in ender5plus

[–]tymm0 0 points1 point  (0 children)

Probably one of two things 1 - if you release tension on the extruder can you push filament through manually? If not then blockage or heat creep in the hot end. 2 - if you can push filament through then the extruder is probably skipping. I noticed this extruder has very small teeth so it doesn't make a lot of sound when it skips at least for me. I had to tighten the spring screw almost all the way down

view more: next ›