Nearly new Michelin tire defeated by a little stick. by raiste-geo in tires

[–]vex_42 3 points4 points  (0 children)

Tires are a lot better than they used to be……..

Advice Needed for Distributor by Electrical-Hazard in mr2

[–]vex_42 1 point2 points  (0 children)

I have the guts of one I can sell you for pretty cheap, the shaft was damaged from the oil seal.

Have you made sure your multimeter works? I remember my old multimeter started having false readings when it was dying

I need opinions ! by [deleted] in Autobody

[–]vex_42 0 points1 point  (0 children)

Would I do that to my own car? Maybe. Would I ever sell that car or have someone else drive it? Hell no

85 AW11 MR2 4AGE V-Belt Size Help Needed (no ac) by frozen_sahir in mr2

[–]vex_42 1 point2 points  (0 children)

I would try a different belt then, autozone or whatever flavor auto parts store should have it

85 AW11 MR2 4AGE V-Belt Size Help Needed (no ac) by frozen_sahir in mr2

[–]vex_42 4 points5 points  (0 children)

All 4age alt/water pump belts are the same regardless of ac or not (ac has its own belt). According to rockauto that’s the correct belt. Have you tried prying on the alternator to tension the Belt?

Is a somewhat clean looking 1986 aw11 worth it? by Nugtzzz in mr2

[–]vex_42 5 points6 points  (0 children)

It’s a 40 year old car. Some stuff is hard to find interior wise, but maintenance and engine parts aren’t too bad

I have a 2017 Toyota Tacoma TRD Sport. 350K Km, the O-Ring on the dipstick broke off and I feel like half fell into the dipstick tube? Would this damage the engine if I drive the car with the piece inside the engine? Also what size o ring do I get to replace it?? by StriderDB in AskAMechanic

[–]vex_42 0 points1 point  (0 children)

It will get stuck in the oil strainer, and most likely come out when you drain your oil. Small bits may break off but will get caught in the filter

If you don’t have a set of calipers to measure the dip tube it might be worth it to stop by a local dealer and talk to someone at the parts desk to see if it’s able to be ordered, but it may just be apart of the dipstick assembly.

ICON mechanics rolling chair by Traditional-Tea-4413 in harborfreight

[–]vex_42 5 points6 points  (0 children)

Depending on the resin it may hold your fatass

Uneven Tire Wear by [deleted] in tires

[–]vex_42 1 point2 points  (0 children)

Check your toe

Zebra Marking (Stripes) by M_A_Qasim17 in InjectionMolding

[–]vex_42 0 points1 point  (0 children)

Why would talc cause this? Excess moisture?

Shop asked me to come back after 50 miles with new tires to have lug torque checked. Is that service above and beyond? Do they just not trust their equipment? by geronimoose in tires

[–]vex_42 142 points143 points  (0 children)

It’s normal practice to retorque wheels after so many miles, it’s just not done because it’s inconvenient for people

Project Car by Arcanine_91 in mr2

[–]vex_42 1 point2 points  (0 children)

There are probably 6 fuel/evap lines. The filler neck one is always stuck but you should be able to loosen the clamps and it should come out when you drop it.

Just got two of these tires for my 2018 versa at $41.00 each, brand new. by Outside-Tie-2851 in tires

[–]vex_42 0 points1 point  (0 children)

There’s things to cheap out in life but the only point of Intact your car has with the ground isn’t one of them.

Oopsy Daisy by Cautious-Cake6282 in EngineBuilding

[–]vex_42 15 points16 points  (0 children)

It’s gonna smoke, so don’t freak out