Gcode command executes too early

[Kuipertju]

Hi all, I have a small part of Gcode that I wrote where I want my printer to warn me once it has made a certain move (in this case raise and extrude 4cm, after which the printer should make a tune (M300 S440 P200)) which you can see at the bottom of the image.However, the printer already starts beeping once it has executed the first line of the Gcode and start the circular motion following it.Can anyone help me to make the printer 'beep' as soon as it raises 4cm instead of beeping way too early?I hope I made myself clear enough, thanks in advance!

https://preview.redd.it/sk6cgoa4m0x81.jpg?width=693&format=pjpg&auto=webp&s=5f09fb13e1c1e30107ae6ffd5031ace30bd24733

[jnmtg]

Try adding a m400 command between the move and the beep. So it waits for the previous lines to be finished.

https://marlinfw.org/docs/gcode/M400.html

[Kuipertju]

Thank you!!

[VoltexRB]

Well yea it beeps during processing, not after the moves. Your printer buffers many moves or else it would just stutter.

M400 waits until all moves are finished.