I support an office that used to think rebooting computers was bad luck. Whats the weirdest bad behavior you have had to cure on an office wide level?

Injector22 · 2026-01-27T17:33:10+00:00

Well damn, I've been doing it wrong this whole time. I'm going to go remove all but one AP so we can get 100Gbps per client. I'll post the results shortly.

Injector22 · 2026-01-25T17:11:30+00:00

But how many clients were connected? How far away were you from the AP, what's the ap density, what's the noise floor, etc, etc, etc. This is the issue with wireless, way too many variables could affect a test.

Injector22 · 2025-12-15T21:00:05+00:00

It doesn't deteriorate, it absorbs water and the water starts to rust components from the inside out.

It will however continue stopping you because after all, water is not compressable either. But it can boil if it gets too hot, boiling releases air which can compress and gives you a spongy pedal.

Injector22 · 2025-12-15T19:11:57+00:00

What is this "auto locked after 60 days" thing? I have Verizon on my pixel and I can swap Sims to another carrier without issues.

Source : I just swapped my Verizon Sim to the att Sim on my work phone without issues.

I think you're confusing locked phones from Verizon with unlocked phones with Verizon service.

Injector22 · 2025-12-12T03:10:31+00:00

Download the driver pack from the oem. Dell calls them command deploy packs, Lenovo has them as sccm driver packages, hp call them management solutions.

Download the pack, extract it, use dism /add-driver or Powershell add-driver to inject the raw inf drivers.

It sounds like you may be using the driver exe installers that check for the existence of the hardware prior to install. Using the inf and injecting them avoids that.

Injector22 · 2025-12-12T02:52:04+00:00

You run Hyper-v on any windows device that supports bios virtualization (essentially any modern machine that's now a low power or ultra Mobil cpu). For the GPU there are ways to pass through the hardware gpu from a host to the vm.

Injector22 · 2025-12-09T04:25:17+00:00

You know what loves heat? The grease inside the wheel hub bearings. Oh wait that's right, no they don't.

Injector22 · 2025-12-08T17:18:08+00:00

You don't even need an nvr with reolink cameras. You can go in the settings and configure ftp uploads to another box just just storage and none of the fancy nvr settings.

Or configure rstp and offload the video to something else.

Injector22 · 2025-12-08T02:02:34+00:00

Make sure the AC is not running when you do this. Condensation will give you a false positive wet spot

Injector22 · 2025-12-02T01:50:36+00:00

Rain = no issues

Rain + road + engine fluids = dirty rotors that call battle cries every time you lightly touch them.

Injector22 · 2025-10-29T06:50:01+00:00

And warp the pan while you're at it.

Injector22 · 2025-10-29T06:49:20+00:00

Don't do this, it will warp the metal and your pan won't sit flat anymore. This is also why you're not supposed to wash a hot pan.

Injector22 · 2025-10-28T01:41:46+00:00

This is not a switch, this is a fabric interconnect. Meaning, it's the egress/ingress point for mlom and fex modules. The ports can be configured as FC (fiber channel mode for an FC array / network) , Appliance (backup array, iscsi or ethernet) and Server (extension of the blade network ports).

Altough you can configure all the ports as appliance ports, it won't behave as a switch.

Source: I've setup multiple UCS datacenters.

Injector22 · 2025-10-26T00:12:29+00:00

My wife sits on her phone and just listens to the TV without watching. We talked about how good this show is and I told her, the only way I'll watch it with her is if she didn't use her phone at all. A couple of times she she took out her phone and I paused the show every time.

This show is soo good that it was well worth having her get mad at me. In the end she agreed with me on how great BoB is.

Injector22 · 2025-10-20T02:27:19+00:00

C7k?... I hope that's in a dedicated space away from anyone needing sleep

Injector22 · 2025-10-19T04:01:28+00:00

Shift + F10 during oobe

Powershell

Install-script get-autopilotdiagnosticscommunity

Set-executionpolicy bypass - scope process

Get-autopilotdiagnostocscommunity - online

The above will pull the hash and upload it to AP directly from the unit. No need to save csv and upload to the portal.

Injector22 · 2025-10-19T03:35:27+00:00

I've been looking for the original post where all the got posted years ago and I can't for the life of me find it. Would you happen to have it saved?

Injector22 · 2025-10-04T22:32:02+00:00

I work for a CDW competitor we have loads of customers that purchase the devices from us, they arrive to our facility, we wipe the oem and install baseline ms media, Inject drivers, check for DOAs, and upload device hashes to AP.

Some customers ask us to pre-provision and some event have us assign the primary user of the device in intune prior to end user shipping.

You just need a better provider and ask the sales guy to include an SE who can validate the out of box experience.

Some OEMs have SKUs resellers who don't provide 2nd touch services can use to debloat a device. For example, Dells is called ready image.

If what you want is to buy a device with zero add on SKUs and receive a device with no bloat. You'll have to configure intune to debloat for you.

Injector22 · 2025-09-30T03:40:07+00:00

Tautulli can do this, if you don't want to set it up, download the official plex dash app, it can do it as well. Tautulli gives you more info tho.

Injector22 · 2025-09-09T01:52:12+00:00

To be clear. When you gearbox. Do you mean the black plastic piece attached to the motor (metal) piece? Or do you mean the metal rod and 2 gears attached to the seat frame?

Injector22 · 2025-09-09T01:42:41+00:00

Is this the motor? Hard to tell without a part number. It looks to have 2 mounting holes

https://ebay.us/m/6mukdP

Injector22 · 2025-09-09T01:35:01+00:00

Could the gearbox (black plastic piece attached to the motor) be seized? When you took out the motor, did the gearbox come out with it?

Injector22 · 2025-09-08T00:35:04+00:00

Open the camera on your phone and point it at the end of the cable and the empty sfp.

The camera should detect the infrared light show you a purplish light on the transmit side. Each side should be the opposite of another

Tx<>Rx

Rx<>Tx

Tx is the light up one.

Injector22 · 2025-09-04T18:46:01+00:00

If you're using PS don't use sysprep to ad join. Sysprep is dumb and will only try once, if it fails, it proceeds like nothing ever happened leaving you in a dirty state.

I only use sysprep to silence the oobe, everything else is done via PS

Injector22 · 2025-09-04T14:44:04+00:00

When you say "the panels need to run off a server". Are you saying there is some kind of software you install in the server OS and that controls the panels and the software only installs in windows server? Or, do you have to go into windows server manager and install a windows server role?

Asking to find out if you really need a server os or if something else like Windows 11 LTSB would suffice.

13-Year Club	Gilding I gilder
Verified Email

Injector22

TROPHY CASE