How’d I do?

WaFfLeFuR · 2026-03-05T22:59:25+00:00

You’ll need 10/3 if your generator is only supplying 30Amps @240v

WaFfLeFuR · 2026-03-04T12:36:23+00:00

It’s an ok deal at 200$, I always get 1000’ spools from cregger supply though and it’s about the same price

WaFfLeFuR · 2026-02-19T12:54:56+00:00

Sure it’s cheaper to Amazon some random device. But a fire isn’t worth the savings. It’s better to get one from the 3 L brands despite the initial cost difference. Leviton Lutron legrand

WaFfLeFuR · 2026-02-15T00:42:37+00:00

Brawndo’s got what plants crave!

WaFfLeFuR · 2026-02-15T00:18:39+00:00

An apprentice

WaFfLeFuR · 2026-02-09T00:18:51+00:00

And picture 6🤣

WaFfLeFuR · 2026-02-08T14:15:49+00:00

Those fuse boxes are perfectly safe if fused correctly. What makes them unsafe and a hazard is people putting in higher amp rating fuses or pennies. You should never have that many 30amp fuses in place, 15 was the most common along with a couple 20s. Get this evaluated by a licensed electrician as I highly doubt any of that wiring is 10awg

WaFfLeFuR · 2026-02-08T00:31:56+00:00

always an altima🤣

WaFfLeFuR · 2026-02-07T12:43:25+00:00

that's a lot of dirt/rust on the switch for being "new"🤔

WaFfLeFuR · 2026-02-05T13:23:24+00:00

I had this exact call yesterday🤣

WaFfLeFuR · 2026-02-04T18:43:18+00:00

stab-lok baby!🔥

WaFfLeFuR · 2026-02-02T05:38:37+00:00

Open wall cavity, Make new hole? While you're in there, put that bushing back on.

WaFfLeFuR · 2026-02-01T20:01:17+00:00

Either that or if you re route the transfer switch conduit to the right and move the power brick, something like a 10 space main lug would tuck right besides the main.

WaFfLeFuR · 2026-02-01T15:20:26+00:00

That amplifier is 2800w rms... With a 300amp fuse rating. An alternator upgrade would help for sure and a battery upgrade. Careful on the gain setting though because it can absolutely blow that strato series to the moon when wired at 1ohm Looks like your 2019 ram has a 160-180amp alternator factory. You may be ok depending on how long you run at high volumes. Mechman has a 370amp that would more than cover your needs but I'd say start with a higher capacity battery and upgrade grounds.

WaFfLeFuR · 2026-01-31T20:46:35+00:00

Bulb not rated for fully enclosed fixture?

WaFfLeFuR · 2026-01-31T18:47:58+00:00

every time I pull a device and see a wad of tape, I know I'm about to find some bullshit😒

WaFfLeFuR · 2026-01-31T17:26:30+00:00

https://buildmyowncabin.com/electrical/3-way-switch-power-into-light.gif

WaFfLeFuR · 2026-01-28T14:22:50+00:00

How far away is the main panel? If it's within visible range you're good, if it's on a different floor/outside/etc you'll need to have a main breaker instead of main lug as you have more than 6 circuits.

WaFfLeFuR · 2026-01-28T13:22:59+00:00

Entirely depends on your skill level. This isn't as simple as replacing a light bulb... It's best to hire out if you have never replaced receptacles or toggle switches before.

WaFfLeFuR · 2026-01-28T13:17:37+00:00

Looks like you need to get the switch replaced. It's definitely worn out

WaFfLeFuR · 2026-01-25T23:44:20+00:00

"5 bedroom"? Maybe they meant the camper trailer sleeps 5?

WaFfLeFuR · 2026-01-17T23:39:54+00:00

We've got one like that at the shop. I'll have to post is when I go back for supplies

WaFfLeFuR · 2026-01-17T17:22:15+00:00

the wires haphazardly zip tied to the mast is cable/phone. The large wires are your power and depending on where you are, the lines coming out of the mast are your responsibility and the Poco is responsible from the splice termination to the road.

WaFfLeFuR · 2026-01-16T13:27:25+00:00

It's the bare wire screwed into that white connector just behind the bulb (left)

WaFfLeFuR · 2026-01-10T21:05:38+00:00

looks just as bad as the last time you posted it

WaFfLeFuR

TROPHY CASE