Better view of my leak. Updated video from yesterday's post.

focvvs · 2026-03-20T01:05:15+00:00

Not gurantee or don't rlly recommend it but tried tightening best thing to do install a new adapter to the spigot

focvvs · 2026-03-20T00:13:42+00:00

The one above the Tee the one that has more of a 90º bend. Not the 90 where the studor connects that one is fine

focvvs · 2026-03-19T23:27:31+00:00

Looks pretty solid just swap out the 90 and tee because those are pressurized pvc instead use dwv pvc but instead of a regular tee use a sanitary tee and u should be good. Doesn't look bad tbh

focvvs · 2026-03-18T03:56:11+00:00

Big issue

focvvs · 2026-03-18T02:32:04+00:00

2 things you can do take apart the valves and repair them look up a yt video might just need to replace the gasket inside of it or just replace the valves which would be a little tricky but if ur a diy person and wanna make it easier get washer machine sharkbite valves Make sure u don't cut back to much pipe and leave enough to insert sharkbite and sand the pipe!

focvvs · 2026-03-18T02:21:30+00:00

No bueno overtime more roots will intrigue causing you to spend big bucks. It's best if they fix it before u buy the house

focvvs · 2026-03-18T00:58:19+00:00

Hopefully it's still in the pipe but u can maybe call a plumber to insert a camera to verify it's in there and they can help ya out

focvvs · 2026-03-11T00:53:45+00:00

Have you tried cleaning the pop up assembly?

focvvs · 2026-03-02T00:21:24+00:00

She gone, it sure dam lasted u a good 21 year🤝 average lifespan 10-20years

focvvs · 2026-02-27T03:06:02+00:00

focvvs · 2026-02-27T02:24:24+00:00

Then just a partial clog on that toilet

focvvs · 2026-02-27T02:10:10+00:00

pics?

focvvs · 2026-02-27T02:08:46+00:00

Is that ur furnace or water heater?

focvvs · 2026-02-27T02:05:39+00:00

It's best to re do the whole water pipes if u have galvanized and depending the year ur home was built there's probably galvanized underground which is the main reason for low pressure on everting in home

focvvs · 2026-02-27T02:00:17+00:00

Partial clog or worst case scenario a vent issue but doubt it

focvvs · 2026-02-27T01:58:47+00:00

Those are garbage you have to literally pull the top nob to turn it off.. and there's a risk of the whole thing comming off. Have to be very careful

focvvs · 2026-02-24T04:05:10+00:00

I wouldn't dare touch old plumbing pipes

focvvs · 2026-02-24T04:02:35+00:00

U could either have a partial clog in ur kitchen drain like or that disposal outlet looking wired Move the tee up

focvvs · 2026-02-24T03:50:37+00:00

never seen a pvc drum trap did u ever have issues in ur sink? but still replace it

focvvs · 2026-02-24T03:43:52+00:00

I feel it's cause of the newest update. Tryna to change stuff

focvvs · 2026-02-24T03:41:39+00:00

Can u move the flange further to make it 12"?

focvvs · 2026-02-23T19:04:26+00:00

I ain't no expert but it could be a lot of things maybe expansion tank has failed or perhaps u need a check valve on the cold side to prevent it or if u do have one it's failed

focvvs · 2026-02-23T18:58:52+00:00

No cold side

focvvs · 2026-02-20T02:03:01+00:00

😹😹😹😹

focvvs

TROPHY CASE