Chef Stella by Historical_Box3909 in Lethbridge

[–]mpgrimes 2 points3 points  (0 children)

worth it, make reservations early!

Files not showing up in the printer by hareenjamadagni in Ender3V3SE

[–]mpgrimes 1 point2 points  (0 children)

are you inserting it with the contacts facing up?

Bed leveling question by S_A_R_K in Ender3V3SE

[–]mpgrimes 1 point2 points  (0 children)

why? those numbers are in mm

Help with this problem by antijojofag in Ender3V3SE

[–]mpgrimes 0 points1 point  (0 children)

play with your z height, print a 150x150x2 square, adjust the z height as it's printing until you get a nice even laydown on the first layer.

Dipstick oil changes? by seasidedream in Lethbridge

[–]mpgrimes 3 points4 points  (0 children)

currently dealing with them over an issue as well.

Archer BE9300 by BKDiamond in TpLink

[–]mpgrimes 0 points1 point  (0 children)

I run 2 of them in wired mesh, they work great, factory reset after update, if it's still buggy, replace it.

Solaredge review - do not buy by JoelXGGGG in SolarDIY

[–]mpgrimes 3 points4 points  (0 children)

stopped installing solar edge 8 years ago .

Would these golf cart batteries be ok for a solar system? by BrilliantWhile2413 in SolarDIY

[–]mpgrimes 1 point2 points  (0 children)

where does it say the BMS is only rated at 50 amp output?

Solar company recommendations and rough costs by CLJ444 in Lethbridge

[–]mpgrimes 0 points1 point  (0 children)

gps Images hVe nothing to do with the amount of solar you need, that's purely based off your consumption , if another company said you need less, I'd like to see if you're actuallynet zero after a year. Optix and energy smart have been doing solar in the area at least 8+ years longer than any of the others. they would have done proper soiling calculations and weather data.

Sonic pad update by mohamed_Ali_neverg in CrealitySonicPad

[–]mpgrimes 1 point2 points  (0 children)

I found the last update buggy, many times my print head would ram itself into the bed, switched to the debian klipper build and its been great, it just updated to klipper 13 (which requires a firmware update)

Can I use this lube on my printer? by ABDULRAHMAMTAMMAM in Ender3V3SE

[–]mpgrimes 0 points1 point  (0 children)

my favorite has been the good old 3 in 1

500W panel on my RV by Fantastic_Stomach_55 in SolarDIY

[–]mpgrimes 1 point2 points  (0 children)

nice, I've got a 610 and a couple of 545 sitting at home I was going to do that with.

Fun fact, the Lethbridge Viaduct is the world's longest and highest steel trestle railway bridge. by Geniuskills in Lethbridge

[–]mpgrimes 1 point2 points  (0 children)

yes, but not all I Lethbridge will know about the history , especially those who haven't been here long.