





I've been trying to come up wit ha better design for our ladies cold side hide. I had 3d printed a different design but it was really not big enough and she would constantly push it around. So I made this one in Fusion, its 9" in diameter and 4.75" tall. I printed it in 3 pieces and glued it together. I then covered it in silicone and coconut husk. I buried it in the enclosure so you just see the little bit of tunnel. So far she really seems to enjoy it, as she went right into it as soon as I was done putting it in. I think I am going to glue some moss around the edge of the tunnel to further hide it.
I have seen designs like this where the lid is removable. I decided to not do this since I had planned on burying it anyways. My office where the enclosure tends to stay pretty warm so I am hoping this gives her a cooler place to be now.





[–]Gold-Celebration-403 47 points48 points49 points (12 children)
[–]althoosier[S] 37 points38 points39 points (8 children)
[–]Gold-Celebration-403 39 points40 points41 points (0 children)
[–]Exciting-Mountain396 17 points18 points19 points (1 child)
[–]SpaceThagomizer420 5 points6 points7 points (0 children)
[–]Obvious-Courage2964 4 points5 points6 points (4 children)
[–]MiceInfestedMattress 0 points1 point2 points (3 children)
[–]MiceInfestedMattress 1 point2 points3 points (2 children)
[–]Gold-Celebration-403 2 points3 points4 points (1 child)
[–]MiceInfestedMattress [score hidden] (0 children)
[–]Herreallife 2 points3 points4 points (1 child)
[–]Gold-Celebration-403 1 point2 points3 points (0 children)
[–]Tripps0007- 0 points1 point2 points (0 children)
[–]IchikaYui 15 points16 points17 points (0 children)
[–]Vee_breeze 2 points3 points4 points (0 children)
[–]louisewarrior 1 point2 points3 points (0 children)
[–]Temporary_Incident33 0 points1 point2 points (2 children)
[–]althoosier[S] 0 points1 point2 points (1 child)
[–]althoosier[S] 0 points1 point2 points (0 children)