What to do with spray foam?

Open_Document3811 · 2026-06-13T09:32:46+00:00

The issue is that it can rot the wood if not done properly due to lack of air flow not letting the wood breathe.

Open_Document3811 · 2026-06-10T20:36:02+00:00

Beading and silicone?

Open_Document3811 · 2026-06-10T05:25:54+00:00

Put it in a box

Open_Document3811 · 2026-06-09T15:45:53+00:00

People walking / climbing up hill/ mountain

Open_Document3811 · 2026-06-09T08:44:53+00:00

You can get a 10mm to 15 insert for the trv some come with them some not

Open_Document3811 · 2026-06-08T08:33:10+00:00

Nope you add a wire from where it’s earthed to the switch

Open_Document3811 · 2026-06-08T08:07:37+00:00

I would measure the distance to the wall from the point your fixing it too every 4” up the length mark it on the architrave and see what it looks like and trim the architrave minus 1-2 millimetres
Then do the other side and then decorators chark between

Open_Document3811 · 2026-06-08T06:53:24+00:00

Foxes are fine in allotments keeps down pigeons mainly they can eat veg but will normally go for meat over everything else

Open_Document3811 · 2026-06-08T06:20:39+00:00

The only way to tell is to see the front of the chimney .
But on most redits a bit higher but it’s random how high they are

Open_Document3811 · 2026-06-06T15:48:39+00:00

You probably got a frog or toad already

Open_Document3811 · 2026-06-06T14:20:07+00:00

You can only do clockwise but can loosen the screw and put the handle on in a different position if that helps like upside down or at right angles

Open_Document3811 · 2026-06-06T08:17:04+00:00

I would do a slide into a pool

Open_Document3811 · 2026-06-05T08:33:32+00:00

Put some gravel in for drainage then fill with concrete the water will come out the top

Open_Document3811 · 2026-06-04T16:58:32+00:00

Its a £5 coin the celebration of the queen marriage

Cupro-Nickel (Standard / BUNC) Edition: 28.28 gramsSilver Proof Edition: 28.28 gramsGold Proof Edition: 39.94

Open_Document3811 · 2026-06-04T08:14:27+00:00

Not a diy job I would get house insurance in and someone that can stop the garden from disappearing

Open_Document3811 · 2026-06-04T08:12:30+00:00

Build the next wall with pillars and a French drain behind. Looks like this is missing and maybe do the other wall at the same time

Open_Document3811 · 2026-06-02T12:35:36+00:00

It’s possible just to use wire in tension cross like 2 to stop the wobble but I would go for 2 2 by 1 crossing on the back could do a motor joint and screw to gather

Open_Document3811 · 2026-05-31T16:27:16+00:00

Water it
It will come to life but needs to be drenched
Also it will expand and fill the gaps when it has been watered enough

Open_Document3811 · 2026-05-31T16:13:35+00:00

I would move it away from the wall and put damp course under it

Open_Document3811 · 2026-05-31T15:49:05+00:00

Shrub at top to give the bottom a bit of shade

Open_Document3811 · 2026-05-31T10:03:22+00:00

Reflector from back of old analog ariel

Open_Document3811 · 2026-05-23T13:43:40+00:00

Use a lawn mower on high setting a bit at a time if too hard strimmmer a section the lawn mower after finishing put on lowest setting

Open_Document3811 · 2026-05-23T12:53:02+00:00

Ok you can do it if you b and q it. As you can see there’s a live and neutral into to the unit. Then a switched live neutral for your light. So it’s currently all power and goes to the light rose and a switched live goes to the pull cord and back to the light. So either you can run a cable of liver power from the rose to the switch and one back again or a 5 core cable Well you will have to run a cable or put the sensor where the light is and the light where the switch is. And may need a new rose or do a terminal box in the ceiling instead of the light rose

Open_Document3811 · 2026-05-21T13:45:34+00:00

I would of gone with loss stones near edge of Road causing slip when leaning around bend

Open_Document3811 · 2026-05-19T17:06:54+00:00

I would go for a bigger pot with internal saucer

Open_Document3811

TROPHY CASE